Segal H C, Briggs C, Kunka S, Casbard A, Harrison P, Machin S J, Murphy M F
National Blood Service, Oxford, UK.
Br J Haematol. 2005 Feb;128(4):520-5. doi: 10.1111/j.1365-2141.2004.05352.x.
Although haematology analysers provide reliable full blood counts, they are known to be inaccurate at enumerating platelets in severe thrombocytopenia. If the thresholds for platelet transfusion, currently set at 10 x 10(9)/l, are to be further reduced, it is vital that the limitations of current analysers are fully understood. The aim of this large multicentre study was to determine the accuracy of haematology analysers in current routine practice for platelet counts below 20 x 10(9)/l. Platelet counts estimated by analysers using optical, impedance and immunological methods were compared with the International Reference Method for platelet counting. The results demonstrated variation in platelet counting between different analysers and even the same type of analyser at different sites. Optical methods for platelet counting on the XE 2100, Advia 120, Cell-Dyn 4000 and H3* were not superior to impedance methods on the XE 2100, LH750 and Pentra analysers. All analysers except one overestimated the platelet count, which would result in under transfusion of platelets. This study highlights the inaccuracies of haematology analysers in platelet counting in severe thrombocytopenia. It re-emphasizes the need for external quality control to improve analyser calibration for samples with low platelet counts, and suggests that the optimal thresholds for prophylactic platelet transfusions should be re-evaluated.
尽管血液学分析仪能提供可靠的全血细胞计数,但众所周知,在严重血小板减少症中对血小板进行计数时,它们并不准确。如果目前设定为10×10⁹/L的血小板输注阈值要进一步降低,充分了解当前分析仪的局限性至关重要。这项大型多中心研究的目的是确定血液学分析仪在当前常规实践中对低于20×10⁹/L的血小板计数的准确性。将使用光学、阻抗和免疫方法的分析仪估计的血小板计数与国际血小板计数参考方法进行比较。结果表明,不同分析仪之间,甚至同一类型分析仪在不同地点的血小板计数存在差异。在XE 2100、Advia 120、Cell-Dyn 4000和H3*上进行血小板计数的光学方法并不优于在XE 2100、LH750和Pentra分析仪上的阻抗方法。除一台分析仪外,所有分析仪都高估了血小板计数,这将导致血小板输注不足。这项研究突出了血液学分析仪在严重血小板减少症中血小板计数的不准确之处。它再次强调了进行外部质量控制以改善低血小板计数样本分析仪校准的必要性,并建议应重新评估预防性血小板输注的最佳阈值。