Woodburn James, Cornwall Mark W, Soames Roger W, Helliwell Philip S
Academic Unit of Musculoskeletal Disease, University of Leeds, Leeds, UK.
J Rheumatol. 2005 Feb;32(2):268-74.
To compare the 3-dimensional (3D) orientation of the tibiotalar, tibiocalcaneal, and intertarsal joints in cadaveric specimens following structural weakening to predetermined ligaments in the peritalar region and medial ankle tendons under axial loads and simulated calcaneal valgus deformity.
Eight fresh-frozen, unembalmed human lower leg and foot specimens were placed in a materials testing machine. The mid-stance period of gait was simulated and the 3D orientation of the tibiotalar, tibiocalcaneal, and intertarsal joints was measured using an electromagnetic motion analysis system. Specimens were then axially loaded at 840 N for 5400 cycles with the calcaneus in its initial orientation and under simulated valgus conditions using a heel wedge following attenuation (multiple stab incisions) of selected ligaments (tibionavicular, anterior tibiotalar and tibiocalcaneal portions of the medial deltoid ligament, the inferior calcaneonavicular ligament, and the superomedial calcaneonavicular ligament) or tendons (tibialis posterior, flexor digitorum longus, and flexor hallucis longus). The joint orientation measurements were then repeated and compared with baseline intact measurements.
Pes planovalgus was observed in 6/8 specimens following testing. The tibiotalar, tibiocalcaneal, talonavicular, and calcaneocuboid joints were more dorsiflexed, everted, and externally rotated following either ligament or tendon compromise. The changes in orientation were small but showed consistent patterns with the smallest changes (typically < 1 degrees ) for the transverse plane and largest (up to 3.5 degrees ) for the frontal plane. The magnitude of change was similar for the tibiotalar and tibiocalcaneal joints, largest for the talonavicular joint, and smallest for the calcaneocuboid joint for both ligament and tendon compromise. The orientation of the talocalcaneal joint was more plantarflexed and everted relative to baseline, for both the ligament and tendon compromise with < 1 degrees of change in orientation about the transverse plane. Under simulated valgus heel conditions, joint orientation was further increased especially about the frontal plane in the direction of eversion. The smallest changes were noted for the calcaneocuboid joint (approximately 1 degrees ), similar change (approximately 2-3 degrees ) for the tibiotalar, tibiocalcaneal and talocalcaneal joints, and the largest changes (> 3 degrees ) for the talonavicular joint. There were no observed differences in the magnitude of change between ligament or tendon condition.
Selective attenuation to either the ligaments supporting the tibiotalar, talocalcaneal, and talonavicular joints or the medial ankle tendons followed by cyclic loading results in small but important changes in the orientation of the tarsal bones consistent with the development of pes planovalgus.
比较在轴向负荷及模拟跟骨外翻畸形情况下,距周区域和内踝肌腱中预定韧带结构减弱后,尸体标本中胫距、胫跟及跗骨间关节的三维(3D)方位。
将8个新鲜冷冻、未防腐处理的人小腿和足部标本置于材料试验机中。模拟步态的中期支撑期,使用电磁运动分析系统测量胫距、胫跟及跗骨间关节的3D方位。然后,在跟骨处于初始方位时,对标本施加840 N的轴向负荷,持续5400个循环,并在对选定韧带(三角韧带的胫舟、胫距前和胫跟部分、跟舟下韧带以及跟舟上内侧韧带)或肌腱(胫后肌、趾长屈肌和拇长屈肌)进行减弱处理(多处刺伤切口)后,使用足跟楔形物模拟外翻情况。之后重复关节方位测量,并与基线完整测量值进行比较。
测试后,8个标本中有6个出现扁平外翻足。在韧带或肌腱受损后,胫距、胫跟、距舟和跟骰关节出现更多背屈、外翻和外旋。方位变化较小,但呈现出一致的模式,其中横平面变化最小(通常<1度),额平面变化最大(可达3.5度)。对于韧带和肌腱受损情况,胫距和胫跟关节的变化幅度相似,距舟关节变化幅度最大,跟骰关节变化幅度最小。对于韧带和肌腱受损情况,距跟关节的方位相对于基线更跖屈和外翻,横平面方位变化<1度。在模拟外翻足跟情况下,关节方位进一步增加,尤其是在额平面上朝着外翻方向增加。跟骰关节变化最小(约1度),胫距、胫跟和距跟关节变化相似(约2 - 3度),距舟关节变化最大(>3度)。在韧带或肌腱情况之间,未观察到变化幅度的差异。
对支撑胫距、距跟和距舟关节的韧带或内踝肌腱进行选择性减弱,随后进行循环负荷,会导致跗骨方位出现虽小但重要的变化,这与扁平外翻足的发展一致。