Suppr超能文献

重建迭代对18F-FDG PET/CT标准化摄取值的影响。

Influence of reconstruction iterations on 18F-FDG PET/CT standardized uptake values.

作者信息

Jaskowiak Chris J, Bianco Jesus A, Perlman Scott B, Fine Jason P

机构信息

Nuclear Medicine Section, Department of Radiology, University of Wisconsin Medical School, Madison, Wisconsin, USA.

出版信息

J Nucl Med. 2005 Mar;46(3):424-8.

Abstract

UNLABELLED

The goal of this study was to evaluate the effect on the average standardized uptake value (avgSUV) and maximum standardized uptake value (maxSUV) of changing the number of iterations in the reconstruction process on studies acquired with PET/CT.

METHODS

Data from 50 human tumors were acquired on a PET/CT scanner, using the CT portion for attenuation correction. Reconstruction was performed using the 2-dimensional reconstruction method of ordered-subsets expectation maximization (OSEM) with 28 subsets and with 1, 2, 3, 4, 5, 10, 20, and 40 iterations. The standardized uptake value (SUV) of the studies was analyzed by positioning a region of interest tightly around the tumor and reproducing the same area on all same-study iterations for SUV measurements.

RESULTS

The differences in mean avgSUV and mean maxSUV were statistically different across different iteration groups. SUV data demonstrated that the avgSUV measurements have the most significant differences between 1 versus 2 iterations and 2 versus 3 iterations. The P values for these comparisons were less then 0.001. For maxSUV, all differences had P values less than 0.001. There also was a systematic increase in the SUVs as the number of iterations increased. The avgSUV increased at early iterations (less than 5), with just 50%-60% increasing after 5 iterations. However, maxSUV increased systematically at early iterations, and this trend continued as the number of iterations increased.

CONCLUSION

The OSEM algorithm converges sooner for avgSUV than for maxSUV. The likely reason is that avgSUV depends on low-frequency features that are recovered with fewer iterations. The differences in maxSUV were likely due to noise, which increased with the number of iterative updates, and to increased resolution and recovery of high-frequency features (i.e., tumor heterogeneity) with a larger number of iterations. Factors that determine the quantitative accuracy of iterative reconstruction may have played an additional role. Given the continued change in maxSUV with iterations, great care must be taken in selecting the number of iterative updates when using it to assess tumors and their response to chemotherapy and radiation therapy. Because 2-5 iterations with 8-28 subsets are being used in clinical settings, these data are pertinent when comparing the SUVs of a tumor before and after therapy.

摘要

未标注

本研究的目的是评估在PET/CT检查中,重建过程中改变迭代次数对平均标准化摄取值(avgSUV)和最大标准化摄取值(maxSUV)的影响。

方法

在PET/CT扫描仪上获取50例人类肿瘤的数据,使用CT部分进行衰减校正。采用有序子集期望最大化(OSEM)的二维重建方法,以28个子集以及1、2、3、4、5、10、20和40次迭代进行重建。通过在肿瘤周围紧密放置感兴趣区域并在所有相同研究的迭代中重现相同区域来测量SUV,从而分析研究的标准化摄取值(SUV)。

结果

不同迭代组之间平均avgSUV和平均maxSUV的差异具有统计学意义。SUV数据表明,avgSUV测量值在1次与2次迭代以及2次与3次迭代之间差异最为显著。这些比较的P值均小于0.001。对于maxSUV,所有差异的P值均小于0.001。随着迭代次数的增加,SUV也有系统性的增加。avgSUV在早期迭代(少于5次)时增加,5次迭代后仅增加50%-60%。然而,maxSUV在早期迭代时系统性增加,并且随着迭代次数的增加这一趋势持续。

结论

OSEM算法对avgSUV的收敛比对maxSUV更快。可能的原因是avgSUV依赖于较少迭代次数就能恢复的低频特征。maxSUV的差异可能是由于噪声,其随着迭代更新次数的增加而增加,以及随着迭代次数增多分辨率提高和高频特征(即肿瘤异质性)的恢复。决定迭代重建定量准确性的因素可能也起到了额外作用。鉴于maxSUV随迭代次数持续变化,在使用其评估肿瘤及其对化疗和放疗的反应时,必须非常谨慎地选择迭代更新次数。由于临床环境中使用的是8-28个子集的2-5次迭代,因此在比较肿瘤治疗前后的SUV时,这些数据具有相关性。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验