Soga Osamu, van Nostrum Cornelus F, Fens Marcel, Rijcken Cristianne J F, Schiffelers Raymond M, Storm Gert, Hennink Wim E
Department of Pharmaceutics, Utrecht Institute for Pharmaceutical Sciences (UIPS), Faculty of Pharmaceutical Sciences, Utrecht University, P.O. Box 80.082, 3508 TB Utrecht, The Netherlands.
J Control Release. 2005 Mar 21;103(2):341-53. doi: 10.1016/j.jconrel.2004.12.009.
The preparation, release and in vitro cytotoxicity of a novel polymeric micellar formulation of paclitaxel (PTX) were investigated. The micelles consisted of an AB block copolymer of poly(N-(2-hydroxypropyl) methacrylamide lactate) and poly(ethylene glycol) (pHPMAmDL-b-PEG). Taking advantage of the thermosensitivity of pHPMAmDL-b-PEG, the loading was done by simply mixing of a small volume of a concentrated PTX solution in ethanol and an aqueous polymer solution and subsequent heating of the resulting solution above the critical micelle temperature of the polymer. PTX could be almost quantitatively loaded in the micelles up to 2 mg/mL. By dynamic light scattering and cryo-transmission electron microscopy, it was shown that PTX-loaded micelles have a mean size around 60 nm with narrow size distribution. At pH 8.8 and 37 degrees C, PTX-loaded micelles destabilized within 10 h due to the hydrolysis of the lactic acid side group of the pHPMAmDL. Because the hydrolysis of the lactic acid side groups is first order in hydroxyl ion concentration, the micelles were stable for about 200 h at physiological conditions. The presence of serum proteins did not have an adverse effect on the stability of the micelles during at least 15 h. Interestingly, the dissolution kinetics of pHPMAmDL-b-PEG micelles was retarded by incorporation of PTX, indicating a strong interaction between PTX and the pHPMAmDL block. The PTX-loaded micelles showed a release of the incorporated 70% of PTX during 20 h at 37 degrees C and at pH 7.4. PTX-loaded pHPMAmDL-b-PEG micelles showed comparable in vitro cytotoxicity against B16F10 cells compared to the Taxol standard formulation containing Cremophor EL, while pHPMAmDL-b-PEG micelles without PTX were far less toxic than the Cremophor EL vehicle. Confocal laser-scanning microscopy (CLSM) and fluorescence activated cell sorting (FACS) analysis of fluorescently labelled micelles showed that pHPMAmDL-b-PEG micelles were internalized by the B16F10 cells. The present results suggest that pHPMAmDL-b-PEG block copolymer micelles are a promising delivery system for the parenteral administration of PTX.
研究了一种新型紫杉醇(PTX)聚合物胶束制剂的制备、释放及体外细胞毒性。该胶束由聚(N-(2-羟丙基)甲基丙烯酰胺乳酸酯)和聚乙二醇(pHPMAmDL-b-PEG)的AB嵌段共聚物组成。利用pHPMAmDL-b-PEG的热敏性,通过将少量乙醇中的浓缩PTX溶液与聚合物水溶液简单混合,然后将所得溶液加热至聚合物的临界胶束温度以上来进行负载。PTX几乎可以定量负载到胶束中,浓度可达2 mg/mL。通过动态光散射和冷冻透射电子显微镜表明,负载PTX的胶束平均尺寸约为60 nm,尺寸分布较窄。在pH 8.8和37℃下,由于pHPMAmDL乳酸侧基的水解,负载PTX的胶束在10小时内不稳定。由于乳酸侧基的水解对氢氧根离子浓度呈一级反应,胶束在生理条件下稳定约200小时。血清蛋白的存在在至少15小时内对胶束的稳定性没有不利影响。有趣的是,PTX的掺入阻碍了pHPMAmDL-b-PEG胶束的溶解动力学,表明PTX与pHPMAmDL嵌段之间有强烈的相互作用。负载PTX的胶束在37℃和pH 7.4下20小时内释放了70%的掺入PTX。与含有聚氧乙烯蓖麻油EL的紫杉醇标准制剂相比,负载PTX的pHPMAmDL-b-PEG胶束对B16F10细胞显示出相当的体外细胞毒性,而不含PTX的pHPMAmDL-b-PEG胶束的毒性远低于聚氧乙烯蓖麻油EL载体。共聚焦激光扫描显微镜(CLSM)和荧光激活细胞分选(FACS)对荧光标记胶束的分析表明,pHPMAmDL-b-PEG胶束被B16F10细胞内化。目前的结果表明,pHPMAmDL-b-PEG嵌段共聚物胶束是一种有前途的PTX胃肠外给药递送系统。