Di Matteo Lucio, Dragoni Walter
P.zza dell'Università 1, Department of Earth Sciences, University of Perugia, 06100 Perugia, Italy.
Ground Water. 2005 Mar-Apr;43(2):242-9. doi: 10.1111/j.1745-6584.2005.0006.x.
Siting wells near streams requires an accurate estimate of the quantity of water derived from the river due to pumping. A number of hydrogeological and hydraulic parameters influence this value. This study estimates stream depletion under steady-state conditions for a variety of hydrogeological systems. A finite differences model was used to analyze several hydrogeological situations, and for each of these the stream depletion was estimated using an advective transport method. An empirical equation for stream depletion was obtained for the case of a stream that partially penetrates the aquifer and a pumping well that is screened over a portion of the aquifer. The derived equation, which is valid for both isotropic and anisotropic conditions, expresses stream depletion as a function of the unit inflow to the river, the discharge of the pumping well, the well screen length, the distance between the river and pumping well, the wetted perimeter, and a new parameter called "overlap," which is defined to be the distance between the riverbed and the top of well screen. The overlap parameter makes it possible to consider indirectly the vertical component of flow, which is accentuated when the well is screened below the streambed. The formula proposed here should be useful in deciding where to locate a pumping well and to decide the appropriate length of its screen.
在溪流附近设置水井需要准确估算抽水导致的从河流获取的水量。一些水文地质和水力参数会影响这个值。本研究估算了各种水文地质系统在稳态条件下的溪流损耗。使用有限差分模型分析了几种水文地质情况,并针对每种情况使用平流输运方法估算了溪流损耗。对于部分穿透含水层的溪流和在含水层一部分上设置滤网的抽水井的情况,得出了一个关于溪流损耗的经验方程。推导得出的方程在各向同性和各向异性条件下均有效,它将溪流损耗表示为河流单位入流量、抽水井出水量、井滤网长度、河流与抽水井之间的距离、湿周以及一个名为“重叠”的新参数的函数,“重叠”定义为河床与井滤网顶部之间的距离。重叠参数使得能够间接考虑水流的垂直分量,当井滤网设置在河床下方时,该垂直分量会更加突出。这里提出的公式在决定抽水井的位置以及确定其滤网的合适长度方面应该会很有用。