Gallardo V, Morales M E, Ruiz M A, Delgado A V
Department of Pharmacy and Pharmaceutical Technology, School of Pharmacy, University of Granada, 18071 Granada, Spain.
Eur J Pharm Sci. 2005 Oct;26(2):170-5. doi: 10.1016/j.ejps.2005.05.008.
This paper aims at explaining the experimental observations of the stability and redispersibility of an aqueous ethylcellulose latex through the electrokinetic characterization of the particles. The surface charge and the electrical double layer thickness play an essential role in the stability of the system, hence the need for a full characterization of the polymeric particles. The effect of both pH and ionic strength of the dispersion medium were investigated. It was found that at acid pH values the latex displays "delayed" or "hindered" sedimentation: in such conditions, the electrophoretic mobility and zeta potential are rather low, indicating a small electrokinetic charge on the particles. At alkaline pH, when the dissociation of ionizable surface groups must be complete, the zeta potential is high and negative. The electrostatic repulsion between polymer particles is responsible for the low sedimentation volume and poor redispersibility of the latex. The effect of NaCl and CaCl(2) concentration on both the zeta potential and stability of the latexes was also investigated: it was found that CaCl(2) has the greatest influence, yielding flocculated, easily re-dispersible systems when its concentration in the dispersion medium is high enough. There qualitative observations were ascertained by means of calculations of the potential energy of interaction between particles. In the case of NaCl solutions, a high and relatively wide potential energy barrier was predicted, that may prevent the particle aggregation. Above 5mM NaCl a shallow minimum in the potential energy curves must lead to the formation of aggregates. Similar results were found with CaCl(2) solutions, although in this case the secondary minima are deeper and appear at lower concentrations.
本文旨在通过对颗粒的电动特性进行表征,来解释乙基纤维素水乳胶的稳定性和再分散性的实验观察结果。表面电荷和电双层厚度在系统稳定性中起着至关重要的作用,因此需要对聚合物颗粒进行全面表征。研究了分散介质的pH值和离子强度的影响。结果发现,在酸性pH值下,乳胶表现出“延迟”或“受阻”沉降:在这种情况下,电泳迁移率和zeta电位相当低,表明颗粒上的电动电荷较小。在碱性pH值下,当可电离表面基团的解离必须完全时,zeta电位高且为负。聚合物颗粒之间的静电排斥导致了乳胶的低沉降体积和差的再分散性。还研究了NaCl和CaCl₂浓度对乳胶的zeta电位和稳定性的影响:发现CaCl₂的影响最大,当其在分散介质中的浓度足够高时,会产生絮凝的、易于再分散的体系。通过计算颗粒间相互作用的势能来确定这些定性观察结果。在NaCl溶液的情况下,预测会有一个高且相对较宽的势能屏障,这可能会阻止颗粒聚集。在5mM NaCl以上,势能曲线中的一个浅最小值必然会导致聚集体的形成。在CaCl₂溶液中也发现了类似的结果,尽管在这种情况下,二级最小值更深且出现在更低的浓度下。