Di Martino F, Giannelli M, Traino A C, Lazzeri M
UO Fisica Sanitaria, Sezione di Fisica Medica, Azienda Ospedaliera Universitaria Pisana, via Roma 67, 56126 Pisa, Italy.
Med Phys. 2005 Jul;32(7):2204-10. doi: 10.1118/1.1940167.
The parallel-plate ionization chamber is the recommended tool for the absorbed dose measurement in pulsed high-energy electron beams. Typically, the electron beams used in radiotherapy have a dose-per-pulse value less then 0.1 cGy/pulse. In this range the factor to correct the response of an ionization chamber for the lack of complete charge collection due to ion recombination (ksat) can be properly evaluated with the standard "two voltage" method proposed by the international dosimetric reports. Very high dose-per-pulse electron beams are employed in some special Linac dedicated to the Intra-Operatory-Radiation-Therapy (IORT). The high dose-per-pulse values (3-13 cGy/pulse) characterizing the IORT electron beams allow to deliver the therapeutic dose (10-20 Gy) in less than a minute. This considerably reduces the IORT procedure time, but some dosimetric problems arise because the standard method to evaluate ksat overestimates its value by 20%. Moreover, if the dose-per-pulse value >1 cGy/pulse, the dependence of ksat on the dose-per-pulse value cannot be neglected for relative dosimetry. In this work the dependence of ksat on the dose-per-pulse value is derived, based on the general equation that describes the ion recombination in the Boag theory. A new equation for ksat, depending on known or measurable quantities, is presented. The new ksat equation is experimentally tested by comparing the absorbed doses to water measured with parallel-plate ionization chambers (Roos and Markus) to that measured using dose-per-pulse independent dosimeters, such as radiochromic films and chemical Fricke dosimeters. These measurements are performed in the high dose-per-pulse (3-13 cGy/pulse) electron beams of the IORT dedicated Linac Hitesys Novac7 (Aprilia-Latina, Italy). The dose measurements made using the parallel-plate chambers and those made using the dose-per-pulse independent dosimeters are in good agreement (<3%). This demonstrates the possibility of using the parallel-plate ionization chambers also for the very high dose-per-pulse (> 1 cGy/pulse) electron-beam dosimetry.
平行板电离室是用于测量脉冲高能电子束吸收剂量的推荐工具。通常,放射治疗中使用的电子束每脉冲剂量值小于0.1 cGy/脉冲。在此范围内,由于离子复合导致电荷收集不完全,用于校正电离室响应的因子(ksat)可以通过国际剂量学报告提出的标准“双电压”方法进行适当评估。一些专门用于术中放射治疗(IORT)的特殊直线加速器会使用非常高的每脉冲剂量电子束。IORT电子束的高每脉冲剂量值(3 - 13 cGy/脉冲)使得能够在不到一分钟的时间内给予治疗剂量(10 - 20 Gy)。这大大缩短了IORT的治疗时间,但出现了一些剂量学问题,因为评估ksat的标准方法会高估其值20%。此外,如果每脉冲剂量值>1 cGy/脉冲,对于相对剂量学而言,ksat对每脉冲剂量值的依赖性就不能被忽略。在这项工作中,基于描述Boag理论中离子复合的一般方程,推导出了ksat对每脉冲剂量值的依赖性。给出了一个新的取决于已知或可测量量的ksat方程。通过比较用平行板电离室(Roos和Markus)测量的水的吸收剂量与使用每脉冲剂量无关的剂量计(如放射变色胶片和化学弗里克剂量计)测量的吸收剂量,对新的ksat方程进行了实验测试。这些测量是在IORT专用直线加速器Hitesys Novac7(意大利阿普利亚 - 拉蒂纳)的高每脉冲剂量(3 - 13 cGy/脉冲)电子束中进行的。使用平行板电离室进行的剂量测量与使用每脉冲剂量无关的剂量计进行的剂量测量结果吻合良好(<3%)。这证明了平行板电离室也可用于非常高的每脉冲剂量(>1 cGy/脉冲)电子束剂量学的可能性。