Tan Fuqing, Chen Zhaodian, Zhao Yilei, Liang Tingbo, Li Jianhui, Wei Jianfeng
Department of Urology, First Affiliated Hospital, College of Medicine, Zhejiang University, Hangzhou, Zhejiang, China.
Microsurgery. 2005;25(7):556-60. doi: 10.1002/micr.20161.
In previous studies, the suture technique and the cuff method were applied to anastomoses of the suprahepatic vena cava (SHVC) in rat orthotopic liver transplantation. However, the anastomosis of SHVC is difficult during transplantation because of the short length of the SHVC. Here, we developed a novel method for anastomoses of SHVC, using a veno-lined stent technique. The veno-lined stent for SHVC anastomosis was prepared after the donor operation. The special veno-lined stent was a 4.0-mm-long polythene tube in which a venous segment from the donor was lined. During the recipient operation, the donor SHVC was anastomosed end-to-end to the recipient SHVC, using the veno-lined stent. Anastomoses of the portal vein and infrahepatic vena cava were performed using a cuff technique. Continuity of the bile duct was established using a stent. The hepatic artery was ligated, and the graft was not arterialized. As controls, the unlined stent, the suture technique, and the cuff method were also used for SHVC anastomoses, respectively, as three control groups with the identical procedures above. In total, 30 orthotopic liver isografts were performed using the veno-lined stent technique. The survival rate was 90% (27/30) after 1 week and 70% (21/30) after 2 months, with normal hepatocellular function. The SHVC anastomosis using a veno-lined stent took 10 +/- 2 (mean +/- SD) min. The anhepatic phase, recipient operative time, and complete operation time were about 14 +/- 2 min, 40 +/- 5 min, and 120 +/- 10 min, respectively. However, in the nonlined stent control group, a total of 20 orthotopic liver isografts used the nonlined stent for SHVC anastomoses, and all failed because of venous thrombosis in SHVC; none survived over 1 week. In the suture technique control group, 40 orthotopic liver isografts were performed using a suture technique for SHVC anastomoses. The results showed no significant difference with those of the veno-lined stent method. But in the cuff method control group, of all 20 orthotopic liver isografts performed using the cuff method for SHVC anastomoses, 10 failed because of failed ligation on the anastomostic site. The survival rates at 1 week and 2 months postoperatively were significantly different from those of the veno-lined stent method. The veno-lined stent technique provides a novel, simple, and reliable method for SHVC anastomoses. It avoids bleeding during suture and the ligation difficulties found with the cuff method. The operation's success rate is satisfactory. This model is successful, and could be applied in various experimental studies.
在先前的研究中,缝合技术和套扎法被应用于大鼠原位肝移植中的肝上腔静脉(SHVC)吻合。然而,由于SHVC长度较短,在移植过程中SHVC的吻合较为困难。在此,我们开发了一种使用静脉内衬支架技术进行SHVC吻合的新方法。用于SHVC吻合的静脉内衬支架在供体手术后制备。特殊的静脉内衬支架是一根4.0毫米长的聚乙烯管,其中衬有来自供体的一段静脉。在受体手术过程中,使用静脉内衬支架将供体SHVC与受体SHVC端端吻合。门静脉和肝下腔静脉的吻合采用套扎技术。使用支架建立胆管的连续性。肝动脉结扎,移植物未进行动脉化。作为对照,无内衬支架、缝合技术和套扎法也分别用于SHVC吻合,作为具有上述相同手术步骤的三个对照组。总共使用静脉内衬支架技术进行了30例原位肝同种移植。1周后的存活率为90%(27/30),2个月后的存活率为70%(21/30),肝细胞功能正常。使用静脉内衬支架进行SHVC吻合耗时10±2(平均值±标准差)分钟。无肝期、受体手术时间和总手术时间分别约为14±2分钟、40±5分钟和120±10分钟。然而,在无内衬支架对照组中,共有20例原位肝同种移植使用无内衬支架进行SHVC吻合,所有移植均因SHVC静脉血栓形成而失败;无一例存活超过1周。在缝合技术对照组中,40例原位肝同种移植使用缝合技术进行SHVC吻合。结果显示与静脉内衬支架法无显著差异。但在套扎法对照组中,所有20例使用套扎法进行SHVC吻合的原位肝同种移植中,有10例因吻合部位结扎失败而失败。术后1周和2个月的存活率与静脉内衬支架法有显著差异。静脉内衬支架技术为SHVC吻合提供了一种新颖、简单且可靠的方法。它避免了缝合过程中的出血以及套扎法中发现的结扎困难。手术成功率令人满意。该模型成功,可应用于各种实验研究。