Suppr超能文献

关于圆柱形亚微米限域对庚氧基氰基联苯影响的热力学和介电研究。

Thermodynamic and dielectric studies concerning the influence of cylindrical submicrometer confinement on heptyloxycyanobiphenyl.

作者信息

Diez S, López D O, de la Fuente M R, Pérez-Jubindo M A, Salud J, Tamarit J Ll

机构信息

Laboratori de Caracterització de Materials (LCM), Departament de Física i Enginyeria Nuclear, ETSEIB, Universitat Politècnica de Catalunya, Diagonal 647, 08028 Barcelona, Spain.

出版信息

J Phys Chem B. 2005 Dec 15;109(49):23209-17. doi: 10.1021/jp054124f.

Abstract

Measurements of the specific heat and the static dielectric permittivity of heptyloxycyanobiphenyl (7OCB) confined to the 0.2 microm diameter parallel cylindrical pores of Anopore membranes in the isotropic phase and nematic mesophase, are presented. A comparison between the bulk and the confined 7OCB in treated and untreated pore wall surfaces using a chemical surfactant (HTBA) is performed. Both the treated and untreated membrane confinements seem to affect the nematic-to-isotropic phase transition by a downshift in transition temperature and some rounding at the specific-heat maximum, in a way similar to that which was earlier published for other liquid crystals confined in the same geometry. The static dielectric measurements clearly point out that untreated membrane confinement is axial, with the nematic director aligned parallel to the pore axis being homeotropic bulklike, i.e., with the nematic director aligned perpendicular to the electrode cell surfaces. After chemical surfactant treatment, the nematic director is constrained in a radial alignment being perpendicular to the pore walls. The dielectric measurements are revealed to be specially sensible to analyze the surface-induced nematic order due to the pore wall. The tricritical nature of the nematic-to-isotropic phase transition in bulk 7OCB as well as in treated and untreated Anopore confined geometries is discussed through both the specific heat and the static dielectric data.

摘要

本文给出了在各向同性相和向列相中介于Anopore膜直径为0.2微米的平行圆柱形孔中的庚氧基氰基联苯(7OCB)的比热和静态介电常数的测量结果。利用化学表面活性剂(HTBA)对处理过和未处理过的孔壁表面的本体7OCB和受限7OCB进行了比较。处理过和未处理过的膜限制似乎都通过转变温度的降低和比热最大值处的一些圆滑来影响向列相到各向同性相的转变,其方式类似于之前针对限制在相同几何形状中的其他液晶所发表的情况。静态介电测量清楚地表明,未处理的膜限制是轴向的,向列指向矢平行于孔轴排列,呈垂直于电极池表面的垂直排列,即类似于本体的垂直排列。化学表面活性剂处理后,向列指向矢被限制在垂直于孔壁的径向排列中。结果表明,介电测量对于分析由于孔壁引起的表面诱导向列序特别灵敏。通过比热和静态介电数据讨论了本体7OCB以及处理过和未处理过的Anopore受限几何形状中向列相到各向同性相转变的三临界点性质。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验