Kołodziejska Justyna
Department of Drug Form Technology, Applied Pharmacy Faculty, Medical University, Lodz.
Polim Med. 2005;35(3):49-66.
Belonging to the classes of: Rofams, Rokopols and Rokanols were used to form the gels soap base. The model gels extensibility was investigated by extensometric method, while their viscosity parameters were determined with cone-plate digital rheometer. Regardless of the applied gel vehicle, model prescriptions of dental anti-inflammatory gels with sodium ibuprofen have been worked out. Natural polysaccharides: xanthan gum, tragacanth, guar gum were the vehicles of the formed gels. New non-ionic surfactants the most beneficial results of rheological measurements were obtained for model gels with Rofam R-15. The calculated areas under extensibility curves of preparations with Rofam R-15 are greater than for gels with Rokopol RF55 or Rokanol OC9. Introduction of Rofam R-15 into the prescription is associated with maintenance of low value of yield stress. When this value is exceeded under the effect of slight shear, the gel does not stay long on the surface of its application. High values of theoretical coefficients of sodium ibuprofen diffusion from gels with Rofam R-15, calculated from Einstein-Smoluchowski equation, are the consequence of their low viscosity. The carried out in vitro comparative testing of the kinetics of sodium ibuprofen release from the gel with Rofam R-15 and from gel with sodium estolate of parallel prescription did not demonstrate any basic differences in the size of the areas under the release curves (14,4046 and 13,5308 c.u. for the vehicle with xanthan gum).
属于罗法姆类、罗科波尔类和罗卡诺尔类的物质被用于形成凝胶皂基。通过拉伸法研究了模型凝胶的延展性,同时用锥板数字流变仪测定了它们的粘度参数。无论使用何种凝胶载体,都已制定出含布洛芬钠的牙科抗炎凝胶的模型处方。天然多糖:黄原胶、黄芪胶、瓜尔胶是所形成凝胶的载体。新型非离子表面活性剂 对于含罗法姆R - 15的模型凝胶,流变学测量获得了最有益的结果。含罗法姆R - 15制剂的拉伸曲线下计算面积大于含罗科波尔RF55或罗卡诺尔OC9的凝胶。在处方中引入罗法姆R - 15与维持低屈服应力值有关。当在轻微剪切作用下超过该值时,凝胶在其应用表面上停留的时间不长。根据爱因斯坦 - 斯莫卢霍夫斯基方程计算,含罗法姆R - 15凝胶中布洛芬钠的理论扩散系数较高,这是其低粘度的结果。对含罗法姆R - 15凝胶和含平行处方雌二醇钠凝胶中布洛芬钠释放动力学进行的体外比较测试表明,释放曲线下面积大小没有任何基本差异(对于含黄原胶的载体,分别为14,4046和13,5308 c.u.)。