Verthé Kristof, Verstraete Willy
Laboratory of Microbial Ecology and Technology (LabMET), Ghent University, Coupure Links 653, 9000 Ghent, Belgium.
Res Microbiol. 2006 Sep;157(7):613-8. doi: 10.1016/j.resmic.2006.02.007. Epub 2006 Mar 2.
In this study, the use of flow cytometry to analyze phage-mediated killing of Enterobacter aerogenes under varying conditions of temperature and nutrient availability was assessed. Bacteriophage UZ1, specific for an E. aerogenes strain, was applied at a multiplicity of infection (MOI) of 1 and 1000 to a Teflon surface, artificially infected with its host at a level of 4.5 log cells. After incubation for 20 h, bacteriophages were quantified using the soft agar layer method. For the quantification of bacterial cells, plate counting and flow cytometric analysis of live/dead stained cells were performed in parallel. At an MOI of 1, phage treatment was successful only after incubation under nutrient-rich conditions at 37 degrees C: E. aerogenes cells were not detected and a tenfold increase in phage UZ1 was observed. At a MOI of 1000, no E. aerogenes cells could be cultured after incubation at 37 and 4 degrees C. However, flow cytometric analysis revealed that lysis did not occur at 4 degrees C but was achieved during subsequent plate culture. In conclusion, the use of flow cytometry enabled identification of culture-based bias during plate culture. The flow cytometric assay used in this study proved to be rapid, as this culture-independent method does not require lengthy incubation periods post-sampling. The bacteriophage-mediated killing of E. aerogenes cells on Teflon surfaces indicated that disinfection of E. aerogenes with bacteriophage UZ1 can be successful when high MOIs are achieved, while at low multiplicities of infection conditions favorable for phage replication are required.
在本研究中,评估了使用流式细胞术分析在不同温度和营养可用性条件下噬菌体介导的对产气肠杆菌的杀伤作用。针对产气肠杆菌菌株的噬菌体UZ1以感染复数(MOI)为1和1000应用于聚四氟乙烯表面,该表面以4.5 log细胞的水平人工感染了其宿主。孵育20小时后,使用软琼脂层法对噬菌体进行定量。对于细菌细胞的定量,并行进行平板计数和对活/死染色细胞的流式细胞术分析。在MOI为1时,仅在37℃富营养条件下孵育后噬菌体处理才成功:未检测到产气肠杆菌细胞,并且观察到噬菌体UZ1增加了十倍。在MOI为1000时,在37℃和4℃孵育后无法培养出产气肠杆菌细胞。然而,流式细胞术分析表明,在4℃时未发生裂解,但在随后的平板培养过程中实现了裂解。总之,流式细胞术的使用能够识别平板培养过程中基于培养的偏差。本研究中使用的流式细胞术检测方法被证明是快速的,因为这种与培养无关的方法在采样后不需要长时间的孵育期。噬菌体介导的对聚四氟乙烯表面产气肠杆菌细胞的杀伤表明,当达到高MOI时,用噬菌体UZ1对产气肠杆菌进行消毒可以成功,而在低感染复数时,需要有利于噬菌体复制的条件。