Sochava I V
Research Institute of Physics, St.-Petersburg State University, Petrodvorets, 198904 St.-Petersburg, Russia.
Biophys Chem. 1997 Nov;69(1):31-41. doi: 10.1016/s0301-4622(97)00072-0.
Calorimetric measurements of absolute heat capacity have been performed for hydrated (11)S-globulin (0 < C(H(2)O) < 25%) and for lysozyme in a concentrated solution, both in the native and denatured states. The denaturation process is observed in hydrated and completely anhydrous proteins; it is accompanied by the appearance of heat capacity increment (Delta(N)(D)C(p)), as is the case for protein solutions. It has been shown that, depending on the temperature and water content, the hydrated denatured proteins can be in a highly elastic or glassy states. Glass transition is also observed in hydrated native proteins. It is found that the denaturation increment Delta(N)(D)C(p) in native protein, like the increment DeltaC(p) in denatured protein in glass transition at low water contents, is due to additional degrees of freedom of thermal motion in the protein globule. In contrast to the conventional notion, comparison of absolute C(p) values for hydrated denatured proteins with the C(p) values for denatured proteins in solution has indicated a dominant contribution of the globule thermal motion to the denaturation increment of protein heat capacity in solutions. The concentration dependence of denaturing heat absorption (temperature at its maximum, T(D), and thermal effect, DeltaQ(D)) and that of glass transition temperature, T(g), for (11)S-globulin have been studied in a wide range of water contents. General polymeric and specific protein features of these dependencies are discussed.
已对水合(11)S -球蛋白(0 < C(H₂O)< 25%)以及浓溶液中的溶菌酶(处于天然和变性状态)进行了绝对热容的量热测量。在水合和完全无水的蛋白质中均观察到了变性过程;与蛋白质溶液的情况一样,该过程伴随着热容增量(Δ(N)(D)Cₚ)的出现。结果表明,根据温度和含水量,水合变性蛋白质可以处于高弹性或玻璃态。在水合天然蛋白质中也观察到了玻璃化转变。研究发现,天然蛋白质中的变性增量Δ(N)(D)Cₚ,与低含水量下变性蛋白质在玻璃化转变时的增量ΔCₚ一样,是由于蛋白质球状体中热运动的额外自由度所致。与传统观念不同的是,将水合变性蛋白质的绝对Cₚ值与溶液中变性蛋白质的Cₚ值进行比较表明,球状体热运动对溶液中蛋白质热容变性增量起主要作用。在很宽的含水量范围内研究了(11)S -球蛋白变性热吸收的浓度依赖性(其最大值时的温度,T(D),以及热效应,ΔQ(D))和玻璃化转变温度T(g)的浓度依赖性。讨论了这些依赖性的一般聚合物特征和特定蛋白质特征。