Suppr超能文献

优化采用微接触印迹法制备的肌红蛋白分子印迹薄膜聚合物的配方。

Optimizing the formulation of a myoglobin molecularly imprinted thin-film polymer--formed using a micro-contact imprinting method.

作者信息

Lin Hsin-Yi, Rick John, Chou Tse-Chuan

机构信息

Department of Chemical Engineering, National Cheng Kung University, Tainan 701, Taiwan, ROC.

出版信息

Biosens Bioelectron. 2007 Jun 15;22(12):3293-301. doi: 10.1016/j.bios.2006.11.015. Epub 2007 Jan 16.

Abstract

Thin-film myoglobin molecularly imprinted polymers have been fabricated using a micro-contact approach. By initially selecting the cross-linker on the basis of it having a minimal recognition for the template and using this as a starting point for functional monomer selection, we have produced myoglobin imprinted polymers with exceptionally high selectivities. The affinity of the polymers, for myoglobin, when prepared with a variety of different cross-linkers and no functional monomer was evaluated. Of these, tetraethylene glycol dimethacrylate (TEGDMA) exhibited the lowest affinity for the template species. Methyl methacrylate (MMA) was chosen as the functional monomer as when it was used in conjunction with TEGDMA, it exhibited maximum selectivity for the template compared to polymers made with other functional monomers. With a MMA to TEGDMA ratio of 1 to 3, the myoglobin molecularly imprinted polymer adsorbed 15.03+/-0.89 x 10(-11)mole/cm(2) of template from a 5.68 x 10(-7)M myoglobin solution, compared to 2.58+/-0.02 x 10(-11)mole/cm(2) for a polymer of similar composition, but formed in the absence of a template. Various washing conditions, using alkaline media to remove the template, were investigated. An extraction solvent comprising 2 wt.% SDS and 0.6 wt.% NaOH used at 80 degrees C for 30 min was shown to give the highest imprinting factor i.e. 5.83 with 72.82% myoglobin removal. The saturation kinetics of template binding to the thin-film MIP were examined and found to display a simple two-phase profile typical of non-cooperative binding. A Scatchard binding plot showed the dissociation constant (K(d)) for the specific binding phase to be 3.4 x 10(-7)M and the binding site capacity to be 7.24 x 10(-11)mole/cm(2). For the non-specific binding phase, K(d) was found to be 1.355 x 10(-5)M and the binding site capacity was determined as 9.62 x 10(-10)mole/cm(2). Selectivity experiments were carried out in both single protein and binary protein systems all using a total protein concentration of 5.68 x 10(-7)M. The molar ratio of adsorbed myoglobin to IgG, HSA and hemoglobin was found to 115.5, 230.9 and 2.5, respectively. While, in binary competition systems, myoglobin selectivity to IgG, HSA and hemoglobin was, respectively, 94.18, 98.21 and 61.09%. Rebinding in natural biological matrices, i.e. human serum or urine, showed the imprinted films to have significantly greater uptake than non-imprinted films. Re-binding in undiluted urine was found to be a facile process, with the imprinting factor, i.e. the ratio of MIP to NIP binding, being determined as 37.4.

摘要

采用微接触法制备了薄膜肌红蛋白分子印迹聚合物。通过首先基于对模板的识别能力最小来选择交联剂,并以此为功能单体选择的起点,我们制备出了具有极高选择性的肌红蛋白印迹聚合物。评估了用各种不同交联剂且不使用功能单体时聚合物对肌红蛋白的亲和力。其中,二缩三乙二醇二甲基丙烯酸酯(TEGDMA)对模板物质的亲和力最低。选择甲基丙烯酸甲酯(MMA)作为功能单体,因为当它与TEGDMA结合使用时,与用其他功能单体制备的聚合物相比,它对模板表现出最大的选择性。当MMA与TEGDMA的比例为1比3时,肌红蛋白分子印迹聚合物从5.68×10⁻⁷M的肌红蛋白溶液中吸附了15.03±0.89×10⁻¹¹摩尔/平方厘米的模板,而组成相似但在无模板情况下形成的聚合物吸附量为2.58±0.02×10⁻¹¹摩尔/平方厘米。研究了使用碱性介质去除模板的各种洗涤条件。结果表明,在80℃下使用含2 wt.% SDS和0.6 wt.% NaOH的萃取溶剂30分钟,可得到最高的印迹因子,即5.83,肌红蛋白去除率为72.82%。研究了模板与薄膜MIP结合的饱和动力学,发现其呈现出典型的非协同结合的简单两相曲线。Scatchard结合图显示,特异性结合阶段的解离常数(Kd)为3.4×10⁻⁷M,结合位点容量为7.24×10⁻¹¹摩尔/平方厘米。对于非特异性结合阶段,Kd为1.355×10⁻⁵M,结合位点容量确定为9.62×10⁻¹⁰摩尔/平方厘米。在单蛋白和双蛋白系统中均进行了选择性实验,所有实验的总蛋白浓度均为5.68×10⁻⁷M。发现吸附的肌红蛋白与IgG、HSA和血红蛋白的摩尔比分别为115.5、230.9和2.5。而在双竞争系统中,肌红蛋白对IgG、HSA和血红蛋白的选择性分别为94.18%、98.21%和61.09%。在天然生物基质即人血清或尿液中的再结合表明,印迹膜的摄取量明显高于非印迹膜。发现在未稀释的尿液中再结合是一个容易的过程,印迹因子即MIP与NIP结合的比率确定为37.4。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验