Suppr超能文献

饮用水总细菌污染的生物发光测定法。

Bioluminescent assay of total bacterial contamination of drinking water.

作者信息

Frundzhyan Valery, Ugarova Natalia

机构信息

Department of Chemistry, Lomonosov Moscow State University, Moscow 119992, Russia.

出版信息

Luminescence. 2007 May-Jun;22(3):241-4. doi: 10.1002/bio.957.

Abstract

A bioluminescent assay of total bacterial contamination (TBC) of drinking water (DW) with a detection limit of approximately 1 CFU/mL and duration of less than 7 h has been developed. The protocol of the TBC assay comprises: incubation of water sample in nutrition broth supplemented with salts mixture, up to 6 h; filtration of bacterial suspension obtained through membrane filter (pore size 0.45 microm); release of bacterial ATP by dimethyl sulphoxide; determination of bacterial ATP concentration using highly sensitive ATP reagent based on recombinant Luciola mingrelica luciferase. To simplify the assay, special luminometer microcuvette Filtravette (New Horizons Diagnostics Corp., USA) are used. A good correlation (R=0.98) between ATP concentration measured after 6 h incubation and initial bacterial titre in DW was observed. Semi-quantitative TBC assay of DW is also available. The TBC value in DW is assessed by the fixation of incubation time required to detect a measurable bioluminescent signal: 3, 4 and 6 h corresponds to 100-1000, 10-100 and 1-10 CFU/mL, respectively.

摘要

已开发出一种用于饮用水(DW)总细菌污染(TBC)的生物发光检测方法,其检测限约为1 CFU/mL,检测时长不到7小时。TBC检测方法的流程包括:将水样在添加了盐混合物的营养肉汤中孵育长达6小时;通过膜过滤器(孔径0.45微米)过滤获得的细菌悬液;用二甲基亚砜释放细菌ATP;使用基于重组明氏摇蚊荧光素酶的高灵敏度ATP试剂测定细菌ATP浓度。为简化检测,使用了特殊的发光计微量比色皿Filtravette(美国新视野诊断公司)。观察到孵育6小时后测得的ATP浓度与DW中的初始细菌滴度之间具有良好的相关性(R = 0.98)。也可进行DW的半定量TBC检测。通过确定检测到可测量生物发光信号所需的孵育时间来评估DW中的TBC值:3、4和6小时分别对应100 - 100(此处原文可能有误,推测为100 - 1000)、10 - 100和1 - 10 CFU/mL。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验