Stulík J, Kozák J, Sebesta P, Vyskocil T, Kryl J, Pelichovská M
Department of Spinal Surgery, University Hospital Motol, Prague.
Acta Chir Orthop Traumatol Cech. 2007 Apr;74(2):79-90.
According to the available sources, no case of total spondylectomy of C2 with preservation of roots, preservation of vertebral arteries and a short fixation without occipitocervical fusion has been so far described in the literature. We decided to perform a radical surgery in a man, now 27 y. o., with solitary metastasis of thyroid adenocarcinoma. In the first step, we applied the posterior surgical approach. The patient was placed prone on a standard operating table with a support of head fixed by adhesive plaster, with the upper cervical spine slightly bent forward. We made a mid-line incision, extending from the external occipital protuberance to the C7 spinous process, controlled bleeding and exposed the C0-C4 section. Subsequently, the entire posterior epistropheus was resected, including most of the pedicles and the entire articular processes for C2-C3 articulation. Both the C2 roots were preserved, however, we had to control quite a profuse bleeding from the venous plexus around the left root. During dissection, the dural sac was damaged in the region of the attachment of the left root, which was treated by suture and covered with Tissucol fibrin sealant. Screws 4.0 mm thick, were inserted into the lateral masses of the atlas after Harms and 4.0mm screws into the C3 and C4 articular processes. On both sides, the screws were connected with 3.2 mm rods, and a transverse stabilizer was then applied to fix the two sides together. Cancellous bone grafts were harvested from the iliac crest and a massive posterolateral and posterior fusion of C1-C4 was performed. The second operation was performed after 21 days. Transoral transmandible approach without tongue splitting was applied. The patient was placed supine on a standard operating table with a support of neck, the head was fixed by adhesive plaster and slightly bent back, and tracheostomy was inserted. An arched incision through the middle of the red lip was made, extending 2 cm straight caudally and arching across the chin and neck, in the midline. On the caudal end we made a transverse inverted T incision. Subsequently, we exposed and osteotomised the mandible using the midline Z-type incision. In order to identify the space between the anterior arch of C1 and the C4 vertebral body, the Synframe retractor was inserted with one blade opening the mouth by pressure on the upper teeth and two blades pressing the tongue caudally. Then an inverted U incision through the mucosa of pharynx was made to identify paravertebral muscles. Caspar retractor was used to separate the muscles and expose C1-C3 laterally, including transversal processes with vertebral arteries. No pathological changes were manifested on the skeleton. First we removed the middle portion of the C2 vertebral body where we did not find any tumour, only sclerotic remodelling. Subsequently, we reamed the lower middle portion of the anterior arch of C1, extracted the dens and cut off the alar ligaments and the apical ligament of dens. The entire dens was then removed. Then we continued on the right side, in the intact part and extracted part of C2 in the region of the atlantoaxial joint, including the rest of the pedicle, and the anterior portion of the transversal process up to the vertebral artery. The posterior part of the transversal process was carefully rotated around the artery and also removed. All parts were extremely hard, sclerotic. The same procedure was followed on the left side where we found a 7 x 10 mm gelatinous greyish tumour in the lateral part of C2 below the atlantoaxial joint. Other parts were again sclerotic. Liquorrhea appeared again from dissection around the C2 root on the left side, the source of which we could not clearly identify. We filled the site of the probable hole with Tissucol fibrin sealant. Between the notch in the lower part of the anterior arch of C1 and the upper end plate of the C3 vertebral body we seated a shaped SynMesh cage with sharp edges providing a very good fixation. No additional fixation was needed. Again we harvested cancellous bone grafts from the iliac crest and placed them on the sides of the cage and at the front between the anterior arch of the atlas and the C3 vertebral body. Subsequently, the muscles were approximated and the mucous tissue of the pharynx repaired. The mandible was fixed by two Miniplate System plates and supported by a dental plate. Total spondylectomy of C2 with preservation of vertebral arteries and roots stabilized only by a short fixation is an extreme surgical procedure suitable only for exceptional cases of young patients with a good bone quality. With regard to potential complications it is of vital importance to consider carefully such operation and consult the proposed therapy with the patient.
根据现有资料,文献中尚未描述过保留神经根、椎动脉且不进行枕颈融合的短节段固定下的C2椎体全切除术。我们决定对一名27岁男性甲状腺腺癌孤立转移患者进行根治性手术。第一步,采用后路手术入路。患者俯卧于标准手术台上,头部用胶布固定,上颈椎稍向前弯曲。做中线切口,从枕外隆凸延伸至C7棘突,控制出血并暴露C0 - C4节段。随后,切除整个寰椎后弓,包括大部分椎弓根以及C2 - C3关节的整个关节突。保留了双侧C2神经根,但左侧神经根周围静脉丛出血较多,需进行控制。在解剖过程中,左侧神经根附着区域的硬脊膜囊受损,进行了缝合并用纤维蛋白密封胶Tissucol覆盖。按照Harms技术,将4.0mm厚的螺钉置入寰椎侧块,4.0mm螺钉置入C3和C4关节突。双侧螺钉用3.2mm棒连接,然后应用横向稳定器将两侧固定在一起。从髂嵴获取松质骨植骨,对C1 - C4进行大块后外侧和后方融合。21天后进行第二次手术。采用经口经下颌入路且不劈开舌头。患者仰卧于标准手术台上,颈部支撑,头部用胶布固定并稍向后仰,行气管切开。在红唇中部做弧形切口,向下直切2cm,然后在中线处弧形跨过下巴和颈部。在尾端做横向倒T形切口。随后,采用中线Z形切口暴露并截骨下颌骨。为了确定C1前弓与C4椎体之间的间隙,插入Synframe牵开器,一个刀片通过对上牙施压张开口腔,两个刀片将舌头向后压。然后在咽部黏膜做倒U形切口以识别椎旁肌。使用Caspar牵开器分离肌肉并从外侧暴露C1 - C3,包括带有椎动脉的横突。骨骼未见病理改变。首先切除C2椎体中部,未发现肿瘤,仅见硬化重塑。随后,磨除C1前弓下部中间部分,取出齿突并切断齿突尖韧带和翼状韧带。然后切除整个齿突。接着在右侧完整部分继续操作,在寰枢关节区域切除部分C2,包括其余椎弓根以及直至椎动脉的横突前部。小心地将横突后部围绕动脉旋转并切除。所有部分都非常坚硬、硬化。左侧采用相同步骤,在寰枢关节下方C2外侧部分发现一个7×10mm的凝胶状灰白色肿瘤。其他部分同样硬化。左侧C2神经根周围解剖时再次出现脑脊液漏,漏口来源不明,用纤维蛋白密封胶Tissucol填充可能的漏口部位。在C1前弓下部切口与C3椎体上端板之间置入一个边缘锋利的成形SynMesh椎间融合器,固定良好,无需额外固定。再次从髂嵴获取松质骨植骨,置于融合器两侧以及寰椎前弓与C3椎体之间的前方。随后,缝合肌肉并修复咽部黏膜组织。下颌骨用两个微型钢板系统固定并用牙托支撑。保留椎动脉和神经根的C2椎体全切除术仅通过短节段固定稳定是一种极端手术,仅适用于骨质良好的年轻患者的特殊情况。考虑到潜在并发症,慎重考虑此类手术并与患者商讨拟行治疗至关重要。