Govindasamy-Lucey S, Lin T, Jaeggi J J, Martinelli C J, Johnson M E, Lucey J A
Wisconsin Center for Dairy Research, University of Wisconsin-Madison, 53706, USA.
J Dairy Sci. 2007 Jun;90(6):2675-88. doi: 10.3168/jds.2006-681.
Sweet cream buttermilk (SCB) is a rich source of phospholipids (PL). Most SCB is sold in a concentrated form. This study was conducted to determine if different concentration processes could affect the behavior of SCB as an ingredient in cheese. Sweet cream buttermilk was concentrated by 3 methods: cold ( < 7 degrees C) UF, cold reverse osmosis (RO), and evaporation (EVAP). A washed, stirred-curd pizza cheese was manufactured using the 3 different types of concentrated SCB as an ingredient in standardized milk. Cheesemilks of casein:fat ratio of 1.0 and final casein content approximately 2.7% were obtained by blending ultrafiltered (UF)-SCB retentate (19.9% solids), RO-SCB retentate (21.9% solids), or EVAP-SCB retentate (36.6% solids) with partially skimmed milk (11.2% solids) and cream (34.6% fat). Control milk (11.0% solids) was standardized by blending partially skimmed milk with cream. Cheese functionality was assessed using dynamic low-amplitude oscillatory rheology, UW Meltprofiler (degree of flow after heating to 60 degrees C), and performance of cheese on pizza. Initial trials with SCB-fortified cheeses resulted in approximately 4 to 5% higher moisture (51 to 52%) than control cheese (approximately 47%). In subsequent trials, procedures were altered to obtain similar moisture content in all cheeses. Fat recoveries were significantly lower in RO- and EVAP-SCB cheeses than in control or UF-SCB cheeses. Nitrogen recoveries were not significantly different but tended to be slightly lower in control cheeses than the various SCB cheeses. Total PL recovered in SCB cheeses ( approximately 32 to 36%) were lower than control ( approximately 41%), even though SCB is high in PL. From the rheology test, the loss tangent curves at temperatures > 40 degrees C increased as cheese aged up to a month and were significantly lower in SCB cheeses than the control, indicating lower meltability. Degree of flow in all the cheeses was similar regardless of the treatment used, and as cheese ripened, it increased for all cheeses. Trichloroacetic acid-soluble N levels were similar in the control and SCB-fortified cheese. On baked pizza, cheese made from milk fortified with UF-SCB tended to have the lowest amount of free oil, but flavor attributes of all cheeses were similar. Addition of concentrated SCB to standardize cheesemilk for pizza cheese did not adversely affect functional properties of cheese but increased cheese moisture without changes in manufacturing procedure.
甜奶油酪乳(SCB)是磷脂(PL)的丰富来源。大多数SCB以浓缩形式出售。本研究旨在确定不同的浓缩工艺是否会影响SCB作为奶酪原料的性能。甜奶油酪乳通过三种方法进行浓缩:低温(<7摄氏度)超滤(UF)、低温反渗透(RO)和蒸发(EVAP)。使用这三种不同类型的浓缩SCB作为标准化牛奶中的原料,制作了一种水洗搅拌凝块披萨奶酪。通过将超滤(UF)-SCB截留物(固体含量19.9%)、RO-SCB截留物(固体含量21.9%)或EVAP-SCB截留物(固体含量36.6%)与部分脱脂牛奶(固体含量11.2%)和奶油(脂肪含量34.6%)混合,获得酪蛋白与脂肪比例为1.0且最终酪蛋白含量约为2.7%的奶酪乳。对照牛奶(固体含量11.0%)通过将部分脱脂牛奶与奶油混合进行标准化。使用动态低振幅振荡流变学、UW Meltprofiler(加热至60摄氏度后的流动程度)以及奶酪在披萨上的表现来评估奶酪的功能。最初使用添加SCB的奶酪进行的试验中,其水分含量(51%至52%)比对照奶酪(约47%)高约4%至5%。在随后的试验中,改变了工艺以在所有奶酪中获得相似的水分含量。RO-SCB奶酪和EVAP-SCB奶酪的脂肪回收率显著低于对照奶酪或UF-SCB奶酪。氮回收率没有显著差异,但对照奶酪中的氮回收率往往略低于各种SCB奶酪。尽管SCB中的PL含量很高,但SCB奶酪中回收的总PL(约32%至36%)低于对照奶酪(约41%)。从流变学测试来看,温度>40摄氏度时的损耗角正切曲线随着奶酪陈化一个月而增加,并且SCB奶酪中的曲线显著低于对照奶酪,表明其可熔性较低。无论采用何种处理方法,所有奶酪的流动程度都相似,并且随着奶酪成熟,所有奶酪的流动程度都增加。对照奶酪和添加SCB的奶酪中三氯乙酸可溶性氮水平相似。在烘焙披萨上,用添加UF-SCB的牛奶制成的奶酪往往游离油含量最低,但所有奶酪的风味特性相似。在制作披萨奶酪的标准化奶酪乳中添加浓缩SCB不会对奶酪的功能特性产生不利影响,但在不改变制造工艺的情况下增加了奶酪的水分含量。