Corsi Richard L, Walker Matthew B, Liljestrand Howard M, Hubbard Heidi F, Poppendieck Dustin G
Department of Civil, Architectural, and Environmental Engineering, University of Texas at Austin, Austin, TX 78712, USA.
J Air Waste Manag Assoc. 2007 May;57(5):576-85. doi: 10.3155/1047-3289.57.5.576.
Several buildings were contaminated with Bacillus anthracis in the fall of 2001. These events required consideration of how to disinfect large indoor spaces for continued worker occupation. The interactions of gaseous disinfectants with indoor materials may inhibit the disinfection process, cause persistence of the disinfectant, and lead to possible byproduct formation and persistence. Methyl bromide (CH3Br) is a candidate for disinfection/deactivation of biological agents in buildings. In this study, 24 indoor materials were exposed to CH3Br for 16 hr at concentrations ranging from 100 to 2500 ppm in 48-L electropolished stainless steel chambers. CH3Br concentrations were measured during and after disinfection. Its interactions with materials were observed to be small, with nearly complete and rapid desorption. Between 3% and 8% of CH3Br adsorbed to four materials (office partition, ceiling tile, particle-board, and gypsum wallboard with satin paint), and the degree of adsorption decreased with increasing relative humidity. The percentage of adsorption to all other materials was <2%. This result suggests that when designing disinfection events with CH3Br, loss to indoor materials can be neglected in terms of disinfectant dose calculations. Possible reaction products were identified and/or quantified before and after exposure to CH3Br. Several monomethylated and dimethylated aliphatic compounds were observed in chamber air at low concentrations after the exposures of six materials to CH3Br. Concentration increases also occurred for chemicals that were observed to naturally off-gas from materials before exposure to CH3Br, suggesting that CH3Br may play a role in enhancing the natural off-gassing of chemicals, for example, by competitive displacement of compounds that already existed in the materials. The results described in this paper should facilitate the design of building disinfection systems involving CH3Br.
2001年秋,几座建筑物被炭疽杆菌污染。这些事件需要考虑如何对大型室内空间进行消毒,以便工人能够继续在其中工作。气态消毒剂与室内材料的相互作用可能会抑制消毒过程,导致消毒剂残留,并可能导致副产物的形成和残留。甲基溴(CH3Br)是用于建筑物中生物制剂消毒/灭活的一种备选物质。在本研究中,将24种室内材料置于48升的电解抛光不锈钢试验箱中,暴露于浓度范围为100至2500 ppm的甲基溴中16小时。在消毒期间和消毒后测量甲基溴的浓度。观察到它与材料的相互作用较小,几乎能完全快速解吸。有四种材料(办公隔断、天花板瓷砖、刨花板和有缎面涂料的石膏墙板)吸附了3%至8%的甲基溴,且吸附程度随相对湿度的增加而降低。对所有其他材料的吸附百分比均小于2%。这一结果表明,在设计使用甲基溴的消毒方案时,就消毒剂剂量计算而言,向室内材料的损失可以忽略不计。在暴露于甲基溴之前和之后,对可能的反应产物进行了鉴定和/或定量。六种材料暴露于甲基溴后,试验箱空气中观察到几种低浓度的单甲基化和二甲基化脂肪族化合物。在暴露于甲基溴之前就观察到会从材料中自然排放的化学物质,其浓度也有所增加,这表明甲基溴可能在增强化学物质的自然排放中发挥作用,例如,通过竞争性取代材料中已存在的化合物。本文所述结果应有助于涉及甲基溴的建筑物消毒系统的设计。