Suppr超能文献

椎体成形术中终板对终板骨水泥强化对椎体强度和刚度的影响。

The influence of endplate-to-endplate cement augmentation on vertebral strength and stiffness in vertebroplasty.

作者信息

Steens Jeroen, Verdonschot Nico, Aalsma Arthur M M, Hosman Allard J F

机构信息

Department of Orthopedic Surgery, Radboud University Nijmegen Medical Center, Nijmegen, The Netherlands.

出版信息

Spine (Phila Pa 1976). 2007 Jul 1;32(15):E419-22. doi: 10.1097/BRS.0b013e318074d4b9.

Abstract

STUDY DESIGN

Controlled in vitro trial.

OBJECTIVE

To study vertebral strength in relation to cement augmentation technique after vertebroplasty and to assess the influence of the biomechanical compression model on postoperative results.

SUMMARY OF BACKGROUND DATA

In the treatment of osteoporotic vertebral fractures, the role of vertebroplasty has been well established. Biomechanical compression models thus far used, compressing vertebrae by only 25% of their initial height, did not show a correlation between cement augmentation volumes and postoperative compression strength. In these studies, even very small volumes of cement seem effective. However, these models may not realistically simulate clinically relevant osteoporotic wedge fractures. We hypothesize that, in clinically relevant osteoporotic wedge fractures, postoperative vertebral body strength is strongly dependent on endplate-to-endplate cement augmentation.

METHODS

Twenty-five intact osteoporotic cadaver vertebrae were obtained (10 lumbar, 15 thoracic). In 21 vertebrae, anterior wedge fractures (AO type A1.2) were created by controlled external force, with preset height reduction by 35%. After height reconstruction, 9 vertebrae were augmented endplate-to-endplate and 12 vertebrae were partially augmented with polymethylmethacrylate (PMMA). Another 4 vertebrae were compressed by only 25%. Posttreatment strength and stiffness of the vertebrae were determined by a compression test identical to the pretreatment compression protocol.

RESULTS

In the 35% compression group, posttreatment strength was significantly decreased in vertebrae that were partially augmented with cement compared with the endplate-to-endplate augmented group (767 +/- 257 N vs. 1141 +/- 325 N, P < 0.01). Postoperative strength amounted 106% +/- 27% of preoperative strength values in the endplate-to-endplate augmented vertebrae, compared with 65% +/- 18% in the partially augmented vertebrae (P < 0.001). In the 25% compression group, results in height restored and augmented vertebrae were similar to the nontreated vertebrae.

CONCLUSIONS

Endplate-to-endplate PMMA augmentation restores the biomechanical properties of vertebrae in clinically relevant anterior wedge fractures. Our preliminary data suggest that biomechanical models with only 25% compressive deformation unlikely form a good model to assess the mechanical effects of cement augmentation in osteoporotic fractures.

摘要

研究设计

体外对照试验。

目的

研究椎体成形术后椎体强度与骨水泥强化技术的关系,并评估生物力学压缩模型对术后结果的影响。

背景资料总结

在骨质疏松性椎体骨折的治疗中,椎体成形术的作用已得到充分确立。迄今为止使用的生物力学压缩模型,仅将椎体压缩至其初始高度的25%,未显示骨水泥强化量与术后压缩强度之间的相关性。在这些研究中,即使是非常少量的骨水泥似乎也有效。然而,这些模型可能无法真实模拟临床相关的骨质疏松性楔形骨折。我们假设,在临床相关的骨质疏松性楔形骨折中,术后椎体强度强烈依赖于终板到终板的骨水泥强化。

方法

获取25个完整的骨质疏松症尸体椎体(10个腰椎,15个胸椎)。在21个椎体中,通过可控外力造成前楔形骨折(AO A1.2型),预设高度降低35%。高度重建后,9个椎体进行终板到终板强化,12个椎体用聚甲基丙烯酸甲酯(PMMA)进行部分强化。另外4个椎体仅压缩25%。通过与预处理压缩方案相同的压缩试验测定椎体治疗后的强度和刚度。

结果

在35%压缩组中,与终板到终板强化组相比,部分用骨水泥强化的椎体治疗后的强度显著降低(7,67±257 N对1,141±325 N,P<0.01)。终板到终板强化椎体的术后强度为术前强度值的106%±27%,而部分强化椎体为65%±18%(P<0.001)。在25%压缩组中,高度恢复和强化椎体的结果与未治疗椎体相似。

结论

终板到终板的PMMA强化可恢复临床相关前楔形骨折中椎体的生物力学特性。我们的初步数据表明,仅25%压缩变形的生物力学模型不太可能成为评估骨质疏松性骨折中骨水泥强化力学效应的良好模型。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验