Salgado J Cristian, Andrews Barbara A, Ortuzar Maria Fernanda, Asenjo Juan A
Centre for Biochemical Engineering and Biotechnology, Department of Chemical Engineering and Biotechnology, Millennium Institute for Cell Dynamics and Biotechnology, University of Chile, Santiago, Region Metropolitana, Chile.
J Chromatogr A. 2008 Jan 18;1178(1-2):134-44. doi: 10.1016/j.chroma.2007.11.064. Epub 2007 Nov 28.
The prediction of the partition behaviour of proteins in aqueous two-phase systems (ATPS) using mathematical models based on their amino acid composition was investigated. The predictive models are based on the average surface hydrophobicity (ASH). The ASH was estimated by means of models that use the three-dimensional structure of proteins and by models that use only the amino acid composition of proteins. These models were evaluated for a set of 11 proteins with known experimental partition coefficient in four-phase systems: polyethylene glycol (PEG) 4000/phosphate, sulfate, citrate and dextran and considering three levels of NaCl concentration (0.0% w/w, 0.6% w/w and 8.8% w/w). The results indicate that such prediction is feasible even though the quality of the prediction depends strongly on the ATPS and its operational conditions such as the NaCl concentration. The ATPS 0 model which use the three-dimensional structure obtains similar results to those given by previous models based on variables measured in the laboratory. In addition it maintains the main characteristics of the hydrophobic resolution and intrinsic hydrophobicity reported before. Three mathematical models, ATPS I-III, based only on the amino acid composition were evaluated. The best results were obtained by the ATPS I model which assumes that all of the amino acids are completely exposed. The performance of the ATPS I model follows the behaviour reported previously, i.e. its correlation coefficients improve as the NaCl concentration increases in the system and, therefore, the effect of the protein hydrophobicity prevails over other effects such as charge or size. Its best predictive performance was obtained for the PEG/dextran system at high NaCl concentration. An increase in the predictive capacity of at least 54.4% with respect to the models which use the three-dimensional structure of the protein was obtained for that system. In addition, the ATPS I model exhibits high correlation coefficients in that system being higher than 0.88 on average. The ATPS I model exhibited correlation coefficients higher than 0.67 for the rest of the ATPS at high NaCl concentration. Finally, we tested our best model, the ATPS I model, on the prediction of the partition coefficient of the protein invertase. We found that the predictive capacities of the ATPS I model are better in PEG/dextran systems, where the relative error of the prediction with respect to the experimental value is 15.6%.
研究了使用基于蛋白质氨基酸组成的数学模型预测蛋白质在双水相体系(ATPS)中的分配行为。预测模型基于平均表面疏水性(ASH)。ASH通过使用蛋白质三维结构的模型以及仅使用蛋白质氨基酸组成的模型进行估算。针对一组在四种体系中具有已知实验分配系数的11种蛋白质对这些模型进行了评估:聚乙二醇(PEG)4000/磷酸盐、硫酸盐、柠檬酸盐和葡聚糖,并考虑了三种NaCl浓度水平(0.0% w/w、0.6% w/w和8.8% w/w)。结果表明,尽管预测质量强烈依赖于ATPS及其操作条件(如NaCl浓度),但这种预测是可行的。使用三维结构的ATPS 0模型获得的结果与之前基于实验室测量变量的模型相似。此外,它保持了之前报道的疏水分辨率和固有疏水性的主要特征。评估了仅基于氨基酸组成的三个数学模型ATPS I - III。最佳结果由假设所有氨基酸完全暴露的ATPS I模型获得。ATPS I模型的性能遵循先前报道的行为,即其相关系数随着体系中NaCl浓度的增加而提高,因此蛋白质疏水性的影响超过电荷或大小等其他影响。在高NaCl浓度下,其在PEG/葡聚糖体系中获得了最佳预测性能。相对于使用蛋白质三维结构的模型,该体系的预测能力提高了至少54.4%。此外,ATPS I模型在该体系中表现出高相关系数,平均高于0.88。在高NaCl浓度下,ATPS I模型在其余ATPS中的相关系数高于0.67。最后,我们在预测蛋白质转化酶的分配系数时测试了我们的最佳模型ATPS I模型。我们发现ATPS I模型在PEG/葡聚糖体系中的预测能力更好,相对于实验值的预测相对误差为15.6%。