Bluvol Nathan, Sheikh Allison, Kornecki Anat, Fernandez David Del Rey, Downey Donal, Fenster Aaron
Imaging Research Laboratories, Robarts Research Institute, London, Ontario N6A 5K8, Canada.
Med Phys. 2008 Feb;35(2):617-28. doi: 10.1118/1.2829871.
Image-guided needle biopsies are currently used to provide a definitive diagnosis of breast cancer; however, difficulties in tumor targeting exist as the ultrasound (US) scan plane and biopsy needle must remain coplanar throughout the procedure to display the actual needle tip position. The additional time associated with aligning and maintaining this coplanar relationship results in increased patient discomfort. Biopsy procedural efficiency is further hindered since needle pathway interpretation is often difficult, especially for needle insertions at large depths that usually require multiple reinsertions. The authors developed a system that would increase the speed and accuracy of current breast biopsy procedures using readily available two-dimensional (2D) US technology. This system is composed of a passive articulated mechanical arm that attaches to a 2D US transducer. The arm is connected to a computer through custom electronics and software, which were developed as an interface for tracking the positioning of the mechanical components in real time. The arm couples to the biopsy needle and provides visual guidance for the physician performing the procedure in the form of a real-time projected needle pathway overlay on an US image of the breast. An agar test phantom, with stainless steel targets interspersed randomly throughout, was used to validate needle trajectory positioning accuracy. The biopsy needle was guided by both the software and hardware components to the targets. The phantom, with the needle inserted and device decoupled, was placed in an x-ray stereotactic mammography (SM) machine. The needle trajectory and bead target locations were determined in three dimensions from the SM images. Results indicated a mean needle trajectory accuracy error of 0.75 +/- 0.42 mm. This is adequate to sample lesions that are < 2 mm in diameter. Chicken tissue test phantoms were used to compare core needle biopsy procedure times between experienced radiologists and inexperienced resident radiologists using free-hand US and the needle guidance system. Cylindrical polyvinyl alcohol cryogel lesions, colored blue, were embedded in chicken tissue. Radiologists identified the lesions, visible as hypoechoic masses in the US images, and performed biopsy using a 14-gauge needle. Procedure times were compared based on experience and the technique performed. Using a pair-wise t test, lower biopsy procedure times were observed when using the guidance system versus the free-hand technique (t = 12.59, p < 0.001). The authors believe that with this improved biopsy guidance they will be able to reduce the "false negative" rate of biopsies, especially in the hands of less experienced physicians.
图像引导下的针吸活检目前用于对乳腺癌进行明确诊断;然而,在肿瘤靶向定位方面存在困难,因为在整个操作过程中,超声(US)扫描平面和活检针必须保持共面,以显示实际的针尖位置。与对齐和维持这种共面关系相关的额外时间会增加患者的不适感。活检操作效率也进一步受到阻碍,因为针道解读往往很困难,尤其是对于在较深位置的针插入操作,通常需要多次重新插入。作者开发了一种系统,该系统将利用现成的二维(2D)超声技术提高当前乳腺活检操作的速度和准确性。该系统由一个连接到二维超声换能器的被动关节式机械臂组成。该机械臂通过定制的电子设备和软件与计算机相连,这些电子设备和软件被开发为实时跟踪机械部件定位的接口。该机械臂与活检针相连,并以乳腺超声图像上实时投影的针道叠加的形式为进行操作的医生提供视觉引导。使用一个琼脂测试模型,其中随机散布着不锈钢靶标,以验证针道定位的准确性。活检针在软件和硬件组件的引导下指向靶标。将插入针且设备分离后的模型放入X射线立体定位乳腺摄影(SM)机中。从SM图像中三维确定针道和珠子靶标的位置。结果表明,针道平均定位误差为0.75±0.42毫米。这足以对直径小于两毫米的病变进行取样。使用鸡组织测试模型比较经验丰富的放射科医生和经验不足的住院放射科医生使用徒手超声和针引导系统进行粗针活检的操作时间。将蓝色的圆柱形聚乙烯醇冷冻凝胶病变嵌入鸡组织中。放射科医生识别出病变(在超声图像中表现为低回声肿块),并使用14号针进行活检。根据经验和所执行的技术比较操作时间。使用配对t检验,观察到使用引导系统时的活检操作时间比徒手技术短(t = 12.59,p < 0.001)。作者认为,有了这种改进的活检引导,他们将能够降低活检的“假阴性”率,尤其是在经验较少的医生手中。