Zhang Min, Horbett Thomas A
Department of Bioengineering, University of Washington, Seattle, 98195, USA.
J Biomed Mater Res A. 2009 Jun;89(3):791-803. doi: 10.1002/jbm.a.32085.
Previous studies have showed that radio-frequency plasma deposited tetraglyme coatings greatly reduced fibrinogen adsorption (Gamma(Fg)) from highly diluted plasmas (0.1 and 1%) and subsequent platelet adhesion under static conditions. In this study, the protein resistant properties of tetraglyme were re-examined with high-concentration plasma, and subsequent platelet adhesion was measured under both static and flow conditions. The resistance of tetraglyme to vWf adsorption (Gamma(vWf)) and the role of vWf in platelet adhesion under flow were also investigated. Gamma(Fg) and Gamma(vWf) were measured with (125)I radiolabeled proteins. Flow studies were done at shear rates of 50 or 500 s(-1) by passing a platelet/red cell suspension through a GlycoTech flow chamber. When adsorbed from a series of increasing plasma concentrations, the adsorption of both proteins to tetraglyme increased steadily, and did not show a peak at intermediate dilutions, i.e., there was no Vroman effect. When plasma concentration was less than 10%, the tetraglyme surface was highly nonfouling, exhibiting ultralow Gamma(Fg) (less than 5 ng/cm(2)) and extremely low platelet adhesion under both static and flow conditions. However, when the adsorption was done from 100% plasma, Gamma(Fg) was much higher ( approximately 85 ng/cm(2)), indicating that tetraglyme surface may not be sufficiently protein-resistant in the physiological environment. To correlate platelet adhesion under flow with Gamma(Fg) and Gamma(vWf), a series of tetraglyme surfaces varying in ether content and protein adsorption was created by varying deposition power. On these surfaces, platelet adhesion at low shear rate depended only on the amount of Gamma(Fg), but under high shear, both Gamma(Fg) and Gamma(vWf) affected platelet adhesion. In particular, it was found that Gamma(vWf) must be reduced to less than 0.4 ng/cm(2) to achieve ultra low platelet adhesion under high shear.
先前的研究表明,射频等离子体沉积的四甘醇二甲醚涂层能极大地减少高稀释血浆(0.1%和1%)中纤维蛋白原的吸附(Gamma(Fg)),并在静态条件下减少随后的血小板黏附。在本研究中,用高浓度血浆重新检测了四甘醇二甲醚的抗蛋白特性,并在静态和流动条件下测量了随后的血小板黏附情况。还研究了四甘醇二甲醚对血管性血友病因子吸附(Gamma(vWf))的抗性以及血管性血友病因子在流动条件下血小板黏附中的作用。Gamma(Fg)和Gamma(vWf)用(125)I放射性标记蛋白进行测量。通过使血小板/红细胞悬液通过GlycoTech流动腔,在50或500 s(-1)的剪切速率下进行流动研究。当从一系列不断增加的血浆浓度中吸附时,两种蛋白在四甘醇二甲醚上的吸附量稳步增加,在中间稀释度时未出现峰值,即不存在弗罗曼效应。当血浆浓度小于10%时,四甘醇二甲醚表面具有高度抗污染性,在静态和流动条件下均表现出超低的Gamma(Fg)(小于5 ng/cm(2))和极低的血小板黏附。然而,当从100%血浆进行吸附时,Gamma(Fg)要高得多(约8 ng/cm(2)),这表明四甘醇二甲醚表面在生理环境中可能没有足够的抗蛋白能力。为了将流动条件下的血小板黏附与Gamma(Fg)和Gamma(vWf)相关联,通过改变沉积功率创建了一系列醚含量和蛋白吸附量不同的四甘醇二甲醚表面。在这些表面上,低剪切速率下的血小板黏附仅取决于Gamma(Fg)的量,但在高剪切下,Gamma(Fg)和Gamma(vWf)均会影响血小板黏附。特别是,发现必须将Gamma(vWf)降低到小于0.4 ng/cm(2),才能在高剪切下实现超低的血小板黏附。