Thompson M R, Liu J, Krump H, Kostanski L K, Fasulo P D, Rodgers W R
MMRI/CAPPA-D, Department of Chemical Engineering, McMaster University, Hamilton, ON L8S 4L7, Canada.
J Colloid Interface Sci. 2008 Aug;324(1-2):177-84. doi: 10.1016/j.jcis.2008.05.004. Epub 2008 May 10.
This paper investigates the influence of supercritical carbon dioxide on the morphology and surface chemistry of three organic modified montmorillonite species. Alkyl based quaternary ammonium surfactants with differing numbers of chains attached, were chosen to vary the degree of CO(2)-philicity exhibited by the organoclay. In a high pressure batch vessel, the different organoclays were suspended in the supercritical solvent at temperatures of 50 and 200 degrees C and pressures of 7.6 and 9.6 MPa and then removed after de-pressurization at 0.2 or 4.8 MPa/s. The structures of these treated clays were characterized by X-ray diffraction (XRD), differential scanning microscopy (DSC), and thermogravimetric analysis (TGA), and their chemical properties were analyzed by various methods including atomic absorption spectroscopy, and water uptake measurement. Solute-solvent interactions plasticized the organic medium while suspended in the supercritical fluid, which resulted in greater chain mobility and further cation exchange. The results indicate that intercalated surfactants exhibiting a paraffin complex arrangement were most likely to experience significant basal expansion, provided the tilt angle was not already close to being perpendicular to the silicate surface. At the lower processing temperature condition, the chemistry of the clay surface was notably altered by the CO(2) associations with the Lewis acid/base sites, which significantly reduced the moisture adsorption capacity of the material. For those organoclays demonstrating basal expansion, it was noted that the resulting particle size was increased due to enhanced porosity.
本文研究了超临界二氧化碳对三种有机改性蒙脱石形态和表面化学的影响。选择了连接链数不同的烷基季铵盐表面活性剂,以改变有机粘土表现出的亲二氧化碳程度。在高压间歇式容器中,将不同的有机粘土在50和200摄氏度、7.6和9.6兆帕的压力下悬浮于超临界溶剂中,然后在0.2或4.8兆帕/秒的降压速率下减压后取出。通过X射线衍射(XRD)、差示扫描显微镜(DSC)和热重分析(TGA)对这些处理过的粘土结构进行了表征,并通过包括原子吸收光谱和吸水率测量在内的各种方法分析了它们的化学性质。溶质 - 溶剂相互作用使悬浮在超临界流体中的有机介质发生塑化,导致链的流动性增强和进一步的阳离子交换。结果表明,只要倾斜角尚未接近垂直于硅酸盐表面,呈现石蜡复合排列的插层表面活性剂最有可能经历显著的基面膨胀。在较低的加工温度条件下,粘土表面的化学性质因二氧化碳与路易斯酸/碱位点的缔合而显著改变,这显著降低了材料的吸湿能力。对于那些表现出基面膨胀的有机粘土,注意到由于孔隙率增加,所得颗粒尺寸增大。