Takebayashi Yoshihiro, Mashimo Yasuaki, Koike Daisuke, Yoda Satoshi, Furuya Takeshi, Sagisaka Masanobu, Otake Katsuto, Sakai Hideki, Abe Masahiko
Nanotechnology Research Institute, National Institute of Advanced Industrial Science and Technology (AIST), Higashi 1-1-1, Tsukuba, Ibaraki 305-8565, Japan.
J Phys Chem B. 2008 Jul 31;112(30):8943-9. doi: 10.1021/jp802578y. Epub 2008 Jul 8.
Fourier transform infrared (FT-IR) spectrum of water-in-supercritical CO(2) microemulsion was measured at 60 degrees C and 30.0 MPa over a wide range of water/CO(2) ratio from 0.0 to 1.2 wt % to study the distribution of water into CO(2), interfacial area around surfactant headgroup, and core water pool. The microemulsion was stabilized by sodium bis(1H,1H,2H, 2H-heptadecafluorodecyl)-2-sulfosuccinate [8FS(EO)(2)] equimolarly mixed with sodium 1-oxo-1-[4-(tridecafluorohexyl)phenyl]-2-hexanesulfonate [FC6HC4] or with poly(ethylene glycol) 2,6,8-trimethyl-4-nonyl ether [TMN-6]. The signal area of the O-H stretching band of water suggested that the number of water molecules in the microemulsion increases linearly with the water/CO(2) ratio, except for a slow initial increase below 0.4 wt % due to a part of water dissolved in CO(2). The amount of water in CO(2) was evaluated by decomposing the bending band of water into two components, one at lower frequency ascribed to water in CO(2) and the other at higher frequency to water in the microemulsion. The decomposition confirmed that CO(2) is saturated with water at the water content of 0.4 wt %. It was also revealed, from the symmetric SO stretching frequency of the surfactant, that the sulfonate headgroup is completely hydrated at the water/CO(2) ratio of 0.4-0.5 wt %. The results demonstrated that water is introduced preferentially into CO(2) and the interfacial area at small water content, and then is loaded into the micelle core after the saturation of CO(2) with water and the full hydration of the surfactant headgroup.
