Xu X, Stewart P S, Chen X
Center for Biofilm Engineering, Montana Bozeman, Montana 59717, USA.
Biotechnol Bioeng. 1996 Jan 5;49(1):93-100. doi: 10.1002/(SICI)1097-0290(19960105)49:1<93::AID-BIT12>3.0.CO;2-C.
An artificial biofilm system consisting of Pseudomonas aeruginosa entrapped in alginate and agarose beads was used to demonstrate transport limitation of the rate of disinfection of entrapped bacteria by chlorine. Alginate gel beads with or without entrapped bacteria consumed chlorine. The specific rate of chlorine consumption increased with increasing cell loading in the gel beads and decreased with increasing bead radius. The value of an observable modulus comparing the rates of reaction and diffusion ranged from less than 0.1 to 8 depending on the bead radius and cell density. The observable modulus was largest for large (3-mm-diameter) beads with high cell loading (1.8 x 10(9) cfu/cm(3)) and smallest for small beads (0.5 mm diameter) with no cells added. A chlorine microelectrode was used to measure chlorine concentration profiles in agarose beads (3.0 mm diameter). Chlorine fully penetrated cell-free agarose beads rapidly; the concentration of chlorine at the bead center reached 50% of the bulk concentration within approximately 10 min after immersion in chlorine solution. When alginate and bacteria were incorporated into an agarose bead, pronounced chlorine concentration gradients persisted within the gel bead. Chlorine did gradually penetrate the bead, but at a greatly retarded rate; the time to reach 50% of the bulk concentration at the bead center was approximately 46 h. The overall rate of disinfection of entrapped bacteria was strongly dependent on cell density and bead radius. Small beads with low initial cell loading (0.5 mm diameter, 1.1 x 10(7) cfu/cm(3)) experienced rapid killing; viable cells could not be detected (<1.6 x 10(5) cfu/cm(3)) after 15 min of treatment in 2.5 mg/L chlorine. In contrast, the number of viable cells in larger beads with a higher initial cell density (3.0 mm diameter, 2.2 x 10(9) cfu/cm(3)) decreased only about 20% after 6 h of treatment in the same solution. Spatially nonuniform killing of bacteria within the beads was demonstrated by measuring the transient release of viable cells during dissolution of the beads. Bacteria were killed preferentially near the bead surface. Experimental results were consistent with transport limitation of the penetration of chlorine into the artificial biofilm arising from a reaction-diffusion interaction. The methods reported here provide tools for diagnosing the mechanism of biofilm resistance to reactive antimicrobial agents in such applications as the treatment of drinking and cooling waters.
一种由包裹在藻酸盐和琼脂糖珠中的铜绿假单胞菌组成的人工生物膜系统,被用于证明氯对包裹细菌的消毒速率存在传输限制。含有或不含包裹细菌的藻酸盐凝胶珠会消耗氯。氯消耗的比速率随着凝胶珠中细胞负载量的增加而增加,随着珠半径的增加而降低。根据珠半径和细胞密度,一个比较反应速率和扩散速率的可观测模量值范围从小于0.1到8。对于细胞负载量高(1.8×10⁹ cfu/cm³)的大珠(直径3毫米),可观测模量最大;对于未添加细胞的小珠(直径0.5毫米),可观测模量最小。使用氯微电极测量琼脂糖珠(直径3.0毫米)中的氯浓度分布。氯能迅速完全穿透无细胞的琼脂糖珠;在浸入氯溶液后约10分钟内,珠中心的氯浓度达到本体浓度的50%。当藻酸盐和细菌被掺入琼脂糖珠中时,凝胶珠内会持续存在明显的氯浓度梯度。氯确实会逐渐穿透珠子,但速率大大减慢;在珠中心达到本体浓度50%的时间约为46小时。包裹细菌的整体消毒速率强烈依赖于细胞密度和珠半径。初始细胞负载量低的小珠(直径0.5毫米,1.1×10⁷ cfu/cm³)经历快速杀灭;在2.5毫克/升氯中处理15分钟后,无法检测到活细胞(<1.6×10⁵ cfu/cm³)。相比之下,在相同溶液中处理6小时后,初始细胞密度较高的大珠(直径3.0毫米,2.2×10⁹ cfu/cm³)中的活细胞数量仅减少约20%。通过测量珠子溶解过程中活细胞的瞬时释放,证明了珠子内细菌的空间不均匀杀灭。细菌在珠表面附近优先被杀死。实验结果与由反应 - 扩散相互作用导致氯渗透到人工生物膜中的传输限制一致。这里报道的方法为诊断生物膜对活性抗菌剂的抗性机制提供了工具,可应用于饮用水和冷却水的处理等领域。