Boston, Mass. From the Division of Plastic Surgery, Beth Israel-Deaconess Medical Center, Harvard Medical School.
Plast Reconstr Surg. 2008 Aug;122(2):497-504. doi: 10.1097/PRS.0b013e31817d5456.
Although the ideal treatment of thumb basal joint osteoarthritis is debated, most surgeons advocate trapeziectomy with ligament reconstruction tendon interposition arthroplasty. However, harvesting and weaving autologous tendon creates scarring, alters wrist kinetics, may prolong recovery, and is time consuming. In this article, the authors propose a new method of arthroplasty using suture anchor suspensionplasty and cadaveric fascia lata interposition.
Thirty-eight consecutive patients who underwent 46 thumb carpometacarpal joint arthroplasties were analyzed retrospectively. All patients were treated by the senior author (J.U.) at one institution over 6 years. Total (n = 17) or partial (n = 29) trapeziectomy was performed followed by Mitek suture anchor suspension of the first to the second metacarpal and cadaveric fascia lata interposition. Preoperative and postoperative evaluations of pain, satisfaction, and strength were undertaken in the short term (3 months) and long term (last follow-up). Follow-up averaged 4 years.
Thirty-one women and seven men were treated, all with advanced osteoarthritis (Eaton stage III and IV). In the short term, 93 percent of thumbs had excellent pain relief, whereas in the long term, pain relief increased to 96 percent. In the short term, 87 percent of cases showed high satisfaction, but this increased to 93 percent in the long term. Average key pinch and tip pinch improvements were 1.5 kg (76 percent improvement, p < 0.001) and 2.0 kg (81 percent improvement, p < 0.001), respectively. Three patients had minor complications.
Thumb basal joint arthroplasty using suture anchor suspension and fascia lata interposition is a reliable, effective, and expeditious technique. It obviates the need for tendon harvest and manipulation while treating the underlying pathomechanics of the disorder.
尽管拇指腕掌关节骨关节炎的理想治疗方法存在争议,但大多数外科医生主张行大多角骨切除术联合韧带重建肌腱间置关节成形术。然而,自体肌腱的采集和编织会造成瘢痕形成,改变腕部动力学,可能会延长恢复时间,并且耗时较长。在本文中,作者提出了一种使用缝线锚钉悬吊成形术和尸体阔筋膜间置的新的关节成形术方法。
回顾性分析了在一家机构由一位资深作者(J.U.)治疗的 38 例连续接受 46 例拇指腕掌关节关节成形术的患者。所有患者均接受了总(n = 17)或部分(n = 29)大多角骨切除术,随后采用 Mitek 缝线锚钉将第一掌骨和第二掌骨悬吊,并进行尸体阔筋膜间置。在短期(3 个月)和长期(末次随访)评估疼痛、满意度和力量。随访平均 4 年。
共治疗了 31 名女性和 7 名男性,均为晚期骨关节炎(Eaton Ⅲ期和Ⅳ期)。在短期,93%的拇指疼痛缓解效果极好,而在长期,疼痛缓解率增加至 96%。在短期,87%的病例满意度较高,但在长期,满意度增加至 93%。平均关键捏力和指尖捏力改善分别为 1.5 千克(76%改善,p < 0.001)和 2.0 千克(81%改善,p < 0.001)。3 例患者出现轻微并发症。
使用缝线锚钉悬吊和阔筋膜间置的拇指腕掌关节成形术是一种可靠、有效和快速的技术。它避免了肌腱采集和操作的需要,同时治疗了疾病的潜在病理力学。