Adaptive modeling of the human rib cage in median sternotomy.

This paper describes a limited computer-analyzed kinematic model of the rib cage that can be adapted to individual subjects. Also described is its validation and use in assessing the changes in chest wall shape after coronary artery bypass graft (CABG) surgery in 12 patients. The positions of a small number of anatomic locations on the thoracic spine, ribs, manubrium, and sternum are measured from lateral and posterior-anterior chest radiographs. The computer program puts these two views together removing the magnification and reconstructs any missing points to give a three-dimensional picture of the rib cage to which mathematical models of the bones are scaled. The patients had chest radiographs taken at total lung capacity (TLC) and residual volume (RV) to investigate the source of the restrictive ventilatory defect that follows CABG. The predictions from the model were tested by comparing full-sized computer plots with the actual chest radiographs. The estimates of the bony structures were accurate to +/- 3 degrees for orientations and +/- 6 mm for positions. We found reduced rib motion both "pump-handle" (theta) and "bucket handle" (psi) going from theta, psi left, psi right = 9 degrees, 10 degrees, 14 degrees to 4 degrees, 10 degrees, 9 degrees, respectively, after surgery with P less than 0.025, 0.42, 0.07. The angles were measured from the horizontal and increased caudally. There was also reduction in the range of angles subtended by the arc of the thoracic vertebrae between TLC and RV, which went from 12 degrees to -1 degrees (P less than 0.015). These data explain the fall in lung volumes that follow CABG and provide insight into the contribution made by the ribs and spine in full inspiration and full expiration.