Arsenault A L
Electron Microscopic Facility, Faculty of Health Sciences, McMaster University, Hamilton, Ontario, Canada.
J Electron Microsc Tech. 1991 Jul;18(3):262-8. doi: 10.1002/jemt.1060180308.
Turkey leg tendons at an early stage of mineralization have been thin sectioned and imaged by electron microscopy. At this stage collagen-associated mineral apatite was found to be present within both the gap and overlap zones. The earliest apatite occurs in a microcrystalline form which gives a rather generalized and characteristic density to both the gap and overlap zones; with subsequent development larger defined apatite crystals arise which span gap/overlap zones. Fourier transformation of such images revealed the major 67 nm axial repeat of the gap/overlap zone plus four other maxima corresponding to repeat spacings of 22, 16, 13, and 11 nm respectively. Computer imaging techniques were used to reconstruct images by using selected spatial frequencies from such transforms. In this manner the subperiodic distributions of mineral were visually enhanced. These subperiodicities are positioned in an asymmetric fashion over the entire D unit repeat aligning with the molecular orientation of the fibril. Analyses of both negatively stained collagen and computer-generated maps of collagen hydrophobicity were compared to the mineral distribution of collagen. Densitometric comparisons showed a positional correlation between the axial banding patterns of mineralized fibrils and those of negatively stained non-mineralized fibrils. Comparable spatial frequencies were also present in transforms between hydrophobic maps and mineral distribution of collagen. These results suggest that the lateral clusterings of hydrophobic residues which span the fibril at specific sites in both the gap and overlap zones serve to prohibit early mineral deposition. This observed hydrophobic influence in combination with the gap space appear as contributing factors in the observed axial distribution of mineral within collagen.
对处于矿化早期阶段的火鸡腿肌腱进行了超薄切片,并通过电子显微镜成像。在此阶段,发现间隙区和重叠区内均存在与胶原蛋白相关的矿物磷灰石。最早的磷灰石以微晶形式出现,使间隙区和重叠区呈现出相当普遍且具有特征性的密度;随着后续的发育,出现了更大的、明确的磷灰石晶体,其跨越间隙/重叠区。对此类图像进行傅里叶变换,揭示了间隙/重叠区主要的67纳米轴向重复以及另外四个最大值,分别对应于22、16、13和11纳米的重复间距。利用计算机成像技术,通过使用此类变换中选定的空间频率来重建图像。通过这种方式,矿物的亚周期分布在视觉上得到了增强。这些亚周期以不对称的方式分布在整个D单元重复序列上,与原纤维的分子取向一致。将负染色胶原蛋白的分析结果以及胶原蛋白疏水性的计算机生成图谱与胶原蛋白的矿物分布进行了比较。密度测定比较表明,矿化原纤维的轴向条纹模式与负染色非矿化原纤维的轴向条纹模式之间存在位置相关性。在疏水性图谱与胶原蛋白矿物分布之间的变换中也存在类似的空间频率。这些结果表明,在间隙区和重叠区的特定位置横跨原纤维的疏水残基的侧向聚集,起到了阻止早期矿物沉积的作用。这种观察到的疏水影响与间隙空间相结合,似乎是观察到的胶原蛋白内矿物轴向分布的促成因素。