Three-dimensional finite element analysis of stress distribution and displacement of the maxilla following surgically assisted rapid maxillary expansion.

PURPOSE

The aim of this study was to investigate the displacement and stress distributions during surgically assisted rapid maxillary expansion under different surgical conditions.

MATERIALS AND METHODS

3-dimensional finite element model of a maxilla with a Hyrax appliance was constructed and an expansion force of 6000 grams was applied using the expansion screw. According to the surgical procedures, 5 groups including a control group without surgery (Group I) were simulated. The experimental groups were as follows; Group II (Le Fort I osteotomy), Group III (Le Fort I osteotomy and paramedian osteotomy), Group IV (Le Fort I osteotomy and pterygomaxillary separation), and Group V (Le Fort I osteotomy, paramedian osteotomy, and pterygomaxillary separation).

RESULTS

Displacement of the maxilla gradually increased from Group 1 to Group 5 in all three planes of space, indicating that combination of the Le Fort I osteotomy with paramedian osteotomy and pterygomaxillary separation produce greatest displacement of the maxilla. By surgical relief, the stress exerted on anchor teeth was significantly reduced.

CONCLUSION

The results suggested that the combination of Le Fort I and paramedian osteotomy with pterygomaxillary separation is an effective procedure for increasing the expansion of the maxilla with lower side effects caused by excessive stresses around the anchor teeth.