School of Chemistry, University of Bristol, UK.
J Am Chem Soc. 2009 Mar 4;131(8):3078-92. doi: 10.1021/ja808807s.
Three methods for the large scale (50-100 g) separation of the secondary phobanes 9-phosphabicyclo[3.3.1]nonane (s-PhobPH) and 9-phosphabicyclo[4.2.1]nonane (a-PhobPH) are described in detail. Selective protonation of s-PhobPH with aqueous HCl in the presence of a-PhobPH is an efficient way to obtain large quantities of a-PhobPH. Selective oxidation of a-PhobPH in an acidified mixture of a-PhobPH and s-PhobPH is an efficient way to obtain large quantities of s-PhobPH. The crystalline, air-stable phosphonium salts [s-PhobP(CH(2)OH)(2)]Cl and [a-PhobP(CH(2)OH)(2)]Cl can be separated by a selective deformylation with aqueous NaOH. a-PhobPH is shown to be a(5)-PhobPH in which the H lies over the five-membered ring. The isomeric a(7)-PhobPH has been detected but isomerizes to a(5)-PhobPH rapidly in the presence of water. s-PhobPH is more basic than a-PhobPH by about 2 pK(a) units in MeOH. Treatment of s-PhobPH with BH(3).THF gives s-PhobPH(BH(3)) and similarly a-PhobPH gives a(5)-PhobPH(BH(3)). Isomerically pure s-PhobPCl and a(5)-PhobPCl are prepared by reaction of the corresponding PhobPH with C(2)Cl(6). The n-butyl phobane s-PhobPBu is prepared by nucleophilic (using s-PhobPH or s-PhobPLi) and electrophilic (using s-PhobPCl) routes. Isomerically pure a(5)-PhobPBu is prepared by treatment of a-PhobPLi with (n)BuBr and a(7)-PhobPBu is prepared by quaternization of a-PhobPH with (n)BuBr followed by deprotonation. From the rates of conversion of a(7)-PhobPBu to a(5)-PhobPBu, the DeltaG(double dagger) (403 K) for P-inversion is calculated to be 38.1 kcal mol(-1) (160 kJ mol(-1)). The donor properties of the individual isomers of PhobPBu were assessed from the following spectroscopic measurements: (i) (1)J(PSe) for PhobP(Se)Bu; (ii) nu(CO) for trans-[RhCl(CO)(PhobPBu)(2)], (iii) (1)J(PtP) for the PEt(3) in trans-[PtCl(2)(PEt(3))(PhobPBu)]. In each case, the data are consistent with the order of sigma-donation being a(7)-PhobPBu > s-PhobPBu > a(5)-PhobPBu. This same order was found when the affinity of the PhobPBu isomers for platinum(II) was investigated by determining the relative stabilities of [Pt(CH(3))(s-PhobPBu)(dppe)][BPh(4)], [Pt(CH(3))(a(5)-PhobPBu)(dppe)][BPh(4)], and [Pt(CH(3))(a(7)-PhobPBu)(dppe)][BPh(4)] from competition experiments. Calculations of the relative stabilities of the isomers of PhobPH, PhobPH(2), and PhobPH(BH(3)) support the conclusions drawn from the experimental results. Moreover, calculations on the frontier orbital energies of PhobPMe isomers and their binding energies to H(+), BH(3), PdCl(3)(-), and PtCl(3)(-) corroborate the experimental observation of the order of sigma-donation being a(7)-PhobPR > s-PhobPR > a(5)-PhobPR. The calculated He(8) steric parameter shows that the bulk of the isomers increases in the order a(7)-PhobPR < s-PhobPR < a(5)-PhobPR. The crystal structures of [a-PhobP(CH(2)OH)(2)][s-PhobP(CH(2)OH)(2)]Cl(2), cis-[PtCl(2)(a(5)-PhobPCH(2)OH)(2)], trans-[PtCl(2)(s-PhobPBu)(2)], and trans-[PtCl(2)(a(7)-PhobPBu)(2)] are reported.
三种方法用于大规模(50-100 克)分离次级膦杂环壬烷 9-膦双环[3.3.1]壬烷(s-PhobPH)和 9-膦双环[4.2.1]壬烷(a-PhobPH)。选择性质子化 s-PhobPH 与水溶液中的 HCl 在 a-PhobPH 的存在下是获得大量 a-PhobPH 的有效方法。在酸性的 a-PhobPH 和 s-PhobPH 混合物中选择性氧化 a-PhobPH 是获得大量 s-PhobPH 的有效方法。结晶、空气稳定的磷盐 [s-PhobP(CH(2)OH)(2)]Cl 和 [a-PhobP(CH(2)OH)(2)]Cl 可以通过选择性去甲酰化用氢氧化钠分离。a-PhobPH 被证明是 a(5)-PhobPH,其中 H 位于五元环上。已经检测到异构的 a(7)-PhobPH,但在存在水的情况下迅速异构化为 a(5)-PhobPH。s-PhobPH 在甲醇中的碱性比 a-PhobPH 约高 2 pK(a)单位。用 BH(3).THF 处理 s-PhobPH 得到 s-PhobPH(BH(3)),类似地,a-PhobPH 得到 a(5)-PhobPH(BH(3))。通过相应的 PhobPH 与 C(2)Cl(6)反应制备了等摩尔 s-PhobPCl 和 a(5)-PhobPCl。通过亲核(使用 s-PhobPH 或 s-PhobPLi)和亲电(使用 s-PhobPCl)途径制备正丁基膦杂环壬烷 s-PhobPBu。等摩尔的 a(5)-PhobPBu 通过用(n)BuBr 处理 a-PhobPLi 制备,a(7)-PhobPBu 通过用(n)BuBr 季铵化随后去质子化制备。从 a(7)-PhobPBu 转化为 a(5)-PhobPBu 的速率计算,P-反转的 DeltaG(double dagger)(403 K)为 38.1 kcal mol(-1)(160 kJ mol(-1))。通过以下光谱测量评估了 PhobPBu 异构体的供电子性质:(i)PhobP(Se)Bu 的(1)J(PSe);(ii)trans-[RhCl(CO)(PhobPBu)(2)] 的 nu(CO);(iii)trans-[PtCl(2)(PEt(3))(PhobPBu)] 中的 PtP 与 PEt(3)的(1)J(PtP)。在每种情况下,数据都与 sigma-供电子顺序一致,即 a(7)-PhobPBu > s-PhobPBu > a(5)-PhobPBu。当通过确定 [Pt(CH(3))(s-PhobPBu)(dppe)][BPh(4)]、[Pt(CH(3))(a(5)-PhobPBu)(dppe)][BPh(4)]和 [Pt(CH(3))(a(7)-PhobPBu)(dppe)][BPh(4)]的相对稳定性来研究 PhobPBu 异构体对铂(II)的亲和力时,也发现了相同的顺序。通过竞争实验从相对稳定性计算得出 PhobPH、PhobPH(2)和 PhobPH(BH(3))的异构体的结论。此外,对 PhobPMe 异构体的前线轨道能量及其与 H(+)、BH(3)、PdCl(3)(-)和 PtCl(3)(-)的结合能的计算也证实了实验结果。观察到的 sigma-供电子顺序为 a(7)-PhobPR > s-PhobPR > a(5)-PhobPR。计算的 He(8)空间参数表明,异构体的体积按 a(7)-PhobPR < s-PhobPR < a(5)-PhobPR 的顺序增加。[a-PhobP(CH(2)OH)(2)][s-PhobP(CH(2)OH)(2)]Cl(2)、cis-[PtCl(2)(a(5)-PhobPCH(2)OH)(2)]、trans-[PtCl(2)(s-PhobPBu)(2)]和 trans-[PtCl(2)(a(7)-PhobPBu)(2)]的晶体结构被报道。