Meltsner Sheridan Griffin, DeWerd Larry A
Department of Medical Physics, University of Wisconsin-Madison, Madison, Wisconsin 53706, USA.
Med Phys. 2009 Feb;36(2):339-50. doi: 10.1118/1.3049587.
No accepted official protocol exists for the dosimetry of the Leksell Gamma Knife (GK) stereotactic radiosurgery device. Establishment of a dosimetry protocol has been complicated by the unique partial-hemisphere arrangement of 201 individual 60Co beams simultaneously focused on the treatment volume and by the rigid geometry of the GK unit itself. This article proposes an air kerma based dosimetry protocol using either an in-air or in-acrylic phantom measurement to determine the absorbed dose rate of fields of the 18 mm helmet of a GK unit. A small-volume air ionization chamber was used to make measurements at the physical isocenter of three GK units. The absorbed dose rate to water was determined using a modified version of the AAPM Task Group 21 protocol designed for use with 60Co-based teletherapy machines. This experimentally determined absorbed dose rate was compared to the treatment planning system (TPS) absorbed dose rate. The TPS used with the GK unit is Leksell GammaPlan. The TPS absorbed dose rate at the time of treatment is the absorbed dose rate determined by the physicist at the time of machine commissioning decay corrected to the treatment date. The TPS absorbed dose rate is defined as absorbed dose rate to water at the isocenter of a water phantom with a radius of 8 cm. Measurements were performed on model B and C Gamma Knife units. The absorbed dose rate to water for the 18 mm helmet determined using air-kerma based calculations is consistently between 1.5% and 2.9% higher than the absorbed dose rate provided by the TPS. These air kerma based measurements allow GK dosimetry to be performed with an established dosimetry protocol and without complications arising from the use of and possible variations in solid phantom material. Measurements were also made with the same ionization chamber in a spherical acrylic phantom for comparison. This methodology will allow further development of calibration methods appropriate for the smaller fields of GK units to be compared to a well established standard.
目前尚无被广泛接受的关于Leksell伽玛刀立体定向放射外科设备剂量测定的官方协议。由于201个单独的60Co束同时聚焦于治疗体积的独特半球部分排列以及伽玛刀设备本身的刚性几何结构,剂量测定协议的建立变得复杂。本文提出了一种基于空气比释动能的剂量测定协议,使用空气中或丙烯酸模体测量来确定伽玛刀设备18毫米头盔各射野的吸收剂量率。使用一个小体积空气电离室在三台伽玛刀设备的物理等中心进行测量。使用为基于60Co的远距离治疗机设计的美国医学物理学家协会任务组21协议的修改版本来确定水的吸收剂量率。将通过实验确定的吸收剂量率与治疗计划系统(TPS)的吸收剂量率进行比较。与伽玛刀设备一起使用的TPS是Leksell GammaPlan。治疗时TPS的吸收剂量率是物理学家在机器调试时确定的吸收剂量率,经衰变校正至治疗日期。TPS吸收剂量率定义为在半径为8厘米的水体模等中心处水的吸收剂量率。对B型和C型伽玛刀设备进行了测量。使用基于空气比释动能的计算确定的18毫米头盔水的吸收剂量率始终比TPS提供的吸收剂量率高1.5%至2.9%。这些基于空气比释动能的测量使得伽玛刀剂量测定能够按照既定的剂量测定协议进行,且不会因使用固体模体材料以及可能的材料变化而产生复杂情况。还使用同一个电离室在球形丙烯酸模体中进行了测量以作比较。这种方法将有助于进一步开发适用于伽玛刀设备较小射野的校准方法,并与一个成熟的标准进行比较。