Byun Chang Kyu, Sharif Iqbal, Desmarteau Darryl D, Creager Stephen E, Korzeniewski Carol
Department of Chemistry, Texas Tech University, Lubbock, Texas 79409-1061, USA.
J Phys Chem B. 2009 May 7;113(18):6299-304. doi: 10.1021/jp900164x.
Structural properties of the proton-exchanged forms of bis[(perfluoroalkyl)sulfonyl] imide (PFSI) ionomer materials were investigated. The hydration and dehydration of samples prepared as thin films and freestanding membrane were probed by applying transmission infrared spectroscopy. Spectral bands were assigned and effects of water incorporation into membrane pores and channels were understood by drawing upon results from related measurements performed on the structurally similar, perfluorosulfonic acid ionomer, Nafion. Both PFSI and Nafion membrane materials display a prominent infrared absorbance band near 1060 cm(-1) that arises from a vibrational mode of the ionizable group present on the side chains that extend from the poly(tetrafluoroethylene) backbone on the polymers. The mode can be traced to symmetric stretching of the -SO(3)(-) (sulfonate) group in Nafion and to antisymmetric S-N-S stretching within the sulfonyl imide end group (-SO(2)(N(-))SO(2)CF(3)) in the PFSI materials. For Nafion samples, the position and width of the band near 1060 cm(-1) are strongly sensitive to membrane hydration, whereas the band position and shape change only slightly during hydration and dehydration of PFSI materials. The possibility for greater charge delocalization over the sulfonyl imide moiety and shielding of hydrophilic species by the terminal -CF(3) group are suggested to explain the differences. These effects also likely influence the stretching modes of the side chain C-O-C groups. A pair of bands, sensitive to hydration and traceable to different C-O-C groups in a side chain, is present in the 970-990 cm(-1) region of Nafion. However, the two features are not well resolved and are less sensitive to hydration in spectra of PFSI samples. The most intense ionomer spectral bands arise from modes involving C-F stretching motion and appear between 1150 and 1250 cm(-1). Toward the high energy side of the envelope, there is substantial overlap with features of sulfonate group antisymmetric SO stretching modes in Nafion, but SO stretching modes of the sulfonyl imide moiety are higher in energy and better resolved in spectra of the PFSIs. During water uptake from a dry state into PFSI materials, a progression of features characteristic of solvated H(3)O(+) species appears across the water O-H stretching (2800-3800 cm(-1)) and H-O-H bending (1500-2000 cm(-1)) regions, similar to responses observed for water inside proton-exchanged Nafion.
研究了双[(全氟烷基)磺酰基]亚胺(PFSI)离聚物材料的质子交换形式的结构性质。通过应用透射红外光谱法对制备成薄膜和独立膜的样品的水合和脱水过程进行了探测。通过借鉴对结构相似的全氟磺酸离聚物Nafion进行的相关测量结果,对光谱带进行了归属,并了解了水进入膜孔和通道的影响。PFSI和Nafion膜材料在1060 cm⁻¹附近均显示出一个突出的红外吸收带,该吸收带源于聚合物中从聚(四氟乙烯)主链延伸出的侧链上存在的可电离基团的振动模式。该模式在Nafion中可追溯到-SO₃⁻(磺酸根)基团的对称拉伸,在PFSI材料中可追溯到磺酰亚胺端基(-SO₂(N⁻)SO₂CF₃)内的不对称S-N-S拉伸。对于Nafion样品,1060 cm⁻¹附近谱带的位置和宽度对膜的水合作用非常敏感,而在PFSI材料的水合和脱水过程中,谱带位置和形状仅略有变化。有人提出,磺酰亚胺部分电荷离域程度更高以及末端-CF₃基团对亲水性物质的屏蔽作用可以解释这些差异。这些效应也可能影响侧链C-O-C基团的拉伸模式。在Nafion的970 - 990 cm⁻¹区域存在一对对水合敏感且可追溯到侧链中不同C-O-C基团的谱带。然而,这两个特征在PFSI样品的光谱中分辨得不好,并且对水合作用不太敏感。离聚物最强的光谱带出现在涉及C-F拉伸运动的模式中,出现在1150至1250 cm⁻¹之间。在包络线的高能侧,与Nafion中磺酸根基团不对称SO拉伸模式的特征有大量重叠,但磺酰亚胺部分的SO拉伸模式能量更高,在PFSI的光谱中分辨得更好。在从干燥状态向PFSI材料吸水的过程中,在水的O-H拉伸(2800 - 3800 cm⁻¹)和H-O-H弯曲(1500 - 2000 cm⁻¹)区域出现了一系列溶剂化H₃O⁺物种特有的特征,这与质子交换的Nafion内部水的响应类似。