Borca Valeria Casanova, Pasquino Massimo, Ozzello Franca, Tofani Santi
S. C. Fisica Sanitaria, Azienda Sanitaria ASL TO 4, Via Di Vittorio 1, 10015 Ivrea, Torino, Italy.
Med Phys. 2009 Apr;36(4):1144-54. doi: 10.1118/1.3081414.
The contribution of a commercially available diode matrix (MapCHECK, provided by Sun Nuclear, Melbourne, FL) for the commissioning procedures of the voxel based Monte Carlo (VMC++) algorithm for electron beams of MasterPlan treatment planning system was investigated. The attention is mainly focused on the calculation in homogeneous and heterogeneous phantoms. With this aim, following a data set similar to that proposed by Electron Collaborative Working Group (ECWG), the dose profiles and two-dimensional (2D) dose distributions measured by the diode matrix were compared with the calculated ones using the gamma analysis method with acceptance criteria for the dose difference and the distance to agreement equal to 4% and 4 mm, respectively. The average and standard deviation of the percentage of points satisfying the constraint gamma < or = 1 are 98.3 +/- 4.1% and 99.3 +/- 1.7% for the 9 and 12 MeV electron beam, respectively, showing that the accuracy of MasterPlan electron beam algorithm is good for simple two-dimensional geometries as well as for more complicated three-dimensional ones. The results are in agreement with those reported in literature by Cygler et al. ["Evaluation of the first commercial Monte Carlo dose calculation engine for electron beam treatment planning," Med. Phys. 31, 142-153 (2004)]. In addition, the authors have also analyzed the response of the 2D array in terms of dose profiles at different depths, comparing the results with those obtained in water phantom using an electron diode. The results show that in the low gradient regions there were no deviations larger than the criteria of acceptability set by Van Dyk et al. ["Commissioning and quality assurance of treatment planning computers," Int. J. Radiat. Oncol. Biol. Phys. 26, 261-273 (1993)]; in the high gradient region, the maximum deviations are less than 2 mm with most of the values less than 1 mm. The present article shows that MapCHECK can play a useful role in the commissioning of electron algorithms of treatment planning systems in the evaluation of the 2D dose distributions in homogeneous and heterogeneous phantoms. In fact, it provides accurate results with the merit of expediting the commissioning process by using measuring device that requires minimal setup time and data processing time.
研究了一种商用二极管矩阵(MapCHECK,由佛罗里达州墨尔本的Sun Nuclear公司提供)对MasterPlan治疗计划系统电子束基于体素的蒙特卡罗(VMC++)算法调试程序的贡献。注意力主要集中在均匀和非均匀体模中的计算。为此,按照电子协作工作组(ECWG)提出的类似数据集,使用伽马分析方法将二极管矩阵测量的剂量分布曲线和二维(2D)剂量分布与计算结果进行比较,剂量差异和一致距离的验收标准分别为4%和4毫米。对于9兆电子伏和12兆电子伏电子束,满足约束伽马≤1的点的百分比的平均值和标准差分别为98.3±4.1%和99.3±1.7%,表明MasterPlan电子束算法对于简单的二维几何形状以及更复杂的三维几何形状的精度都很好。结果与Cygler等人在文献中报道的结果一致[《用于电子束治疗计划的首个商用蒙特卡罗剂量计算引擎的评估》,《医学物理》31,142 - 153(2004)]。此外,作者还根据不同深度的剂量分布曲线分析了二维阵列的响应,并将结果与使用电子二极管在水体模中获得的结果进行比较。结果表明,在低梯度区域,偏差不大于Van Dyk等人设定的可接受标准[《治疗计划计算机的调试和质量保证》,《国际放射肿瘤学、生物学、物理学杂志》26,261 - 273(1993)];在高梯度区域,最大偏差小于2毫米,大多数值小于1毫米。本文表明,MapCHECK在治疗计划系统电子算法的调试中,对于评估均匀和非均匀体模中的二维剂量分布可以发挥有益作用。事实上,它提供了准确的结果,优点是使用设置时间和数据处理时间最少的测量设备加快了调试过程。