Passos Marieta L C, Santos Ana M, Pereira Ana I, Santos J Rodrigo, Santos Agostinho J C, Saraiva M Lúcia M F S, Lima José L F C
REQUIMTE, Serviço de Química-Física, Faculdade de Farmácia, Universidade do Porto, Rua Aníbal Cunha, 164, 4099-030 Porto, Portugal.
Talanta. 2009 Sep 15;79(4):1094-9. doi: 10.1016/j.talanta.2009.02.054. Epub 2009 Mar 13.
The estimation of the time since death known as postmortem interval (PMI) is a main issue in the field of forensic science and legal medicine. In this work it is proposed a sequential injection system for the determination of hypoxanthine and potassium in the same sample of vitreous humor since the concentrations of both parameters change with PMI and the vitreous humor has been regarded as the ideal extracellular fluid for these kinds of determinations. By measuring both parameters the accuracy of estimation of PMI can be increased, and the effects of factors which influence the values in postmortem chemistry minimized. Hypoxanthine determination is based on its oxidation to uric acid (290 nm), catalyzed by immobilized xanthine oxidase, and the quantification of potassium levels in vitreous humor was performed using a tubular potassium ion-selective electrode. With a unique analytical cycle both analytes were evaluated being potassium levels determined during the degradation of hypoxanthine in the enzymatic reactor. Working concentration ranges between 6.04-40.00 micromol L(-1) and 7.00 x 10(-5) to 1.00 x 10(-1)mmol L(-1) were obtained, for hypoxanthine and potassium, respectively. The method proved to be reproducible with R.S.D. <5% for hypoxanthine and <3% for potassium. Sampling rate was approximately 30 per hour for the sequential determination of both parameters being 15 and 60 determinations per hour if hypoxanthine or potassium, where evaluated independently. Statistical evaluation at the 95% confidence level showed good agreement between the results obtained, for the vitreous humor samples, with both the SIA system and the comparison batch procedures. Moreover the methodology has low environmental impact in agreement with the demands of green analytical chemistry as only 2.7 mL of chemical waste is produced during both determinations.
死后间隔时间(PMI)的估计是法医学和法医学领域的一个主要问题。在这项工作中,提出了一种顺序注射系统,用于测定同一玻璃体液样本中的次黄嘌呤和钾,因为这两个参数的浓度会随PMI变化,并且玻璃体液被认为是进行此类测定的理想细胞外液。通过测量这两个参数,可以提高PMI估计的准确性,并将影响死后化学值的因素的影响降至最低。次黄嘌呤的测定基于其在固定化黄嘌呤氧化酶催化下氧化为尿酸(290nm),玻璃体液中钾水平的定量使用管状钾离子选择性电极进行。通过一个独特的分析循环,对两种分析物进行了评估,其中钾水平是在酶反应器中次黄嘌呤降解过程中测定的。次黄嘌呤和钾的工作浓度范围分别为6.04 - 40.00 μmol L⁻¹和7.00×10⁻⁵至1.00×10⁻¹ mmol L⁻¹。该方法被证明具有可重复性,次黄嘌呤的相对标准偏差(R.S.D.)<5%,钾的相对标准偏差<3%。顺序测定这两个参数时的采样率约为每小时30次,如果单独评估次黄嘌呤或钾,则每小时分别为15次和60次。在95%置信水平下的统计评估表明,对于玻璃体液样本,SIA系统获得的结果与比较批处理程序之间具有良好的一致性。此外,该方法对环境的影响较小,符合绿色分析化学的要求,因为在两次测定过程中仅产生2.7 mL化学废物。