Department of Mechanical Engineering, University of Ottawa, Ottawa, Ontario K1N 6N5, Canada.
Department of Mechanical and Industrial Engineering, University of Toronto, Toronto, Ontario M5S 3G8, Canada.
J Biomed Mater Res B Appl Biomater. 2009 Nov;91(2):876-886. doi: 10.1002/jbm.b.31470.
This study investigates the effect of PLGA 85/15 scaffold on the cell growth and viability of a cell line, and the degradation of the scaffold in different media. The cell line used was human promyelocytic leukemia cells (HL-60). Three different media were considered: distilled water, a phosphate buffered saline (PBS) solution, and HL-60 cell line. Porous PLGA 85/15 scaffolds were prepared with an optimized gas foaming/salt leaching technique using a NaCl/polymer mass ratio of five, a saturation pressure of 5.52 MPa and a saturation time of 12 h. The cell growth and viability were not impaired by the presence of the scaffold. The mass change of the scaffold due to degradation over the period was varied only by 4% across all three media. The average macropore size and molecular weight decreased as the degradation time increased in each medium. The scaffolds maintained mechanical and structural integrity throughout the study in all three media over the degradation period studied, and the change of Young's modulus of the scaffold under wet condition was not significant. Overall, PBS solution most strongly affected physical and mechanical properties, followed by dH(2)O and HL-60 cells. The distinct variations of the scaffold's properties using different media, demonstrated the importance of carefully selecting the medium to perform in vitro studies. The medium must replicate the actual environment where the scaffold would be used, to represent accurately the changes in properties that the scaffold would be undergoing.
本研究考察了 PLGA 85/15 支架对细胞系细胞生长和活力的影响,以及支架在不同介质中的降解情况。所用的细胞系是人早幼粒细胞白血病细胞(HL-60)。考虑了三种不同的介质:蒸馏水、磷酸盐缓冲盐水(PBS)溶液和 HL-60 细胞系。使用优化的气体发泡/盐浸出技术制备多孔 PLGA 85/15 支架,NaCl/聚合物质量比为五,饱和压力为 5.52 MPa,饱和时间为 12 h。支架的存在并没有损害细胞的生长和活力。在所有三种介质中,由于降解导致支架质量的变化仅在 4%以内。在每种介质中,随着降解时间的增加,支架的平均大孔尺寸和分子量均减小。在所有三种介质中,支架在整个降解期间都保持机械和结构完整性,在湿条件下支架的杨氏模量变化不显著。总的来说,PBS 溶液对物理和机械性能的影响最大,其次是 dH(2)O 和 HL-60 细胞。使用不同的介质对支架性能的明显变化表明,在进行体外研究时,仔细选择介质非常重要。介质必须复制支架将使用的实际环境,以准确代表支架将经历的性能变化。