Somers M, Engelborghs Y
Laboratory of Chemical and Biological Dynamics, Katholieke Universiteit te Leuven, Belgium.
Eur Biophys J. 1990;18(4):239-44. doi: 10.1007/BF00183377.
Optically anisotropic zones occur spontaneously in solutions of microtubules. These tactoids, in which microtubules are arranged in parallel arrays, can be visualized by their birefringence. With microtubules assembled in the presence of associated proteins (MAPs), birefringence appears immediately after nucleation of polymerization, even at relatively low protein concentrations. It is not dependent on whether the assembly is initiated by temperature jump or by isothermal addition of GTP. With pure tubulin, assembled in buffers containing 25% glycerol or 4% dimethylsulfoxide and/or taxol, birefringence appears within a few hours, but it can be speeded up by gentle agitation. With tubulin assembled in the presence of MAPs, spontaneous orientation occurs simultaneously with polymerization. This may be due to the existence of more pronounced repulsive forces between microtubules when they are covered with MAPs. A simple calculation of the covolume, suggests that tactoid formation is expected for microtubules of lengths of 5 to 10 microns at protein concentrations in the range 1 to 3 mg/ml (as observed), and that repulsive forces will promote tactoid formation at even lower protein concentrations.
微管溶液中会自发出现光学各向异性区域。这些类晶体中,微管呈平行排列,可通过其双折射现象观察到。在有相关蛋白(MAPs)存在的情况下组装微管时,即使在相对较低的蛋白浓度下,聚合作用成核后双折射现象立即出现。这与组装过程是由温度跃升引发还是通过等温添加GTP引发无关。对于在含有25%甘油或4%二甲基亚砜和/或紫杉醇的缓冲液中组装的纯微管蛋白,双折射现象在数小时内出现,但轻轻搅拌可加速其出现。在有MAPs存在的情况下组装微管蛋白时,自发取向与聚合作用同时发生。这可能是由于微管被MAPs覆盖时,微管之间存在更明显的排斥力。对共体积的简单计算表明,在1至3毫克/毫升的蛋白浓度范围内(如观察到的),长度为5至10微米的微管有望形成类晶体,并且排斥力会在更低的蛋白浓度下促进类晶体的形成。