Department of Biomedical Kinesiology, Faculty of Kinesiology and Rehabilitation Sciences, K.U. Leuven, Leuven, Belgium.
J Biomech. 2009 Dec 11;42(16):2636-41. doi: 10.1016/j.jbiomech.2009.08.027. Epub 2009 Sep 23.
Compared to isometric contraction, the force producing capacity of muscle is reduced (force depression, FD) after a work producing shortening phase. It has been suggested that FD results from an inhibition of cross-bridge binding. Because the rate constants of the exponential force (re)development are thought to be primarily determined by cross-bridge attachment/detachment rate, we aimed to investigate the components of force redevelopment (REDEV) after 0.6, 1.2 and 2.4mm shortening, resulting in varying amounts of FD (from about 5% to about 16%), in mouse soleus muscle (n=11). Compared to isometric force development (DEV), the time to reach steady-state during REDEV was about 3 times longer (370 versus 1261ms) increasing with increasing amplitude. Contrary to a single, a double exponential function with one component set equal to the rate constant of DEV (14.3s(-1)), accurately described REDEV (RMS<0.8%). The rate constant of the additional slow component decreased with increasing shortening amplitude and was associated with work delivered during shortening (R(2)=0.75) and FD (R(2)=0.77). We concluded that a work related slow exponential component is induced to the trajectory of incomplete force recovery after shortening, causing FD. These results suggest that after shortening, aside from cross-bridges with normal attachment/detachment rate, cross-bridges with reduced cycling rate are active.
与等长收缩相比,肌肉在产生缩短相的工作后产生的力量能力降低(力抑制,FD)。有人认为 FD 是由于横桥结合的抑制所致。由于指数力(再)发展的速率常数主要被认为取决于横桥附着/脱离的速率,我们旨在研究在 0.6、1.2 和 2.4mm 缩短后力再发展(REDEV)的组成部分,导致不同程度的 FD(约 5%至约 16%),在小鼠比目鱼肌中(n=11)。与等长力发展(DEV)相比,REDEV 达到稳态的时间大约长 3 倍(370 与 1261ms),随着幅度的增加而增加。与单指数函数相反,具有一个组件的双指数函数等于 DEV 的速率常数(14.3s(-1)),准确地描述了 REDEV(RMS<0.8%)。附加的慢组件的速率常数随着缩短幅度的增加而降低,并且与缩短期间传递的工作(R(2)=0.75)和 FD(R(2)=0.77)相关。我们得出结论,在缩短后,除了具有正常附着/脱离速率的横桥之外,具有降低循环速率的横桥也处于活跃状态。这些结果表明,除了具有正常附着/脱离速率的横桥之外,缩短后,还会出现一种与工作相关的、较慢的指数成分,导致 FD。