Suppr超能文献

成品皮废料的铬酸萃取和厌氧生物降解。

Finished leather waste chromium acid extraction and anaerobic biodegradation of the products.

机构信息

Centro Tecnológico do Calçado de Portugal (Portuguese Footwear Technological Centre), CTCP Rua de Fundões, Devesa Velha, 3700-121 São João da Madeira, Portugal.

出版信息

Waste Manag. 2010 Jun;30(6):1091-100. doi: 10.1016/j.wasman.2009.12.006. Epub 2010 Jan 8.

Abstract

Due to the amounts of chromium in the leachate resulting from leather leaching tests, chromium sulfate tanned leather wastes are very often considered hazardous wastes. To overcome this problem, one option could be recovering the chromium and, consequently, lowering its content in the leather scrap. With this objective, chromium leather scrap was leached with sulfuric acid solutions at low temperature also aiming at maximizing chromium removal with minimum attack of the leather matrix. The effects of leather scrap dimension, sulfuric acid and sodium sulfate concentration in the solutions, as well as extraction time and temperature on chromium recovery were studied, and, additionally, organic matrix degradation was evaluated. The best conditions found for chromium recovery were leather scrap conditioning using 25mL of concentrated H(2)SO(4)/L solution at 293 or 313K during 3 or 6days. Under such conditions, 30-60+/-5% of chromium was recovered and as low as 3-6+/-1% of the leather total organic carbon (TOC) was dissolved. Using such treatment, the leather scrap area and volume are reduced and the residue is a more brittle material showing enhanced anaerobic biodegradability. Although good recovery results were achieved, due to the fact that the amount of chromium in eluate exceeded the threshold value this waste was still hazardous. Thus, it needs to be methodically washed in order to remove all the chromium de-linked from collagen.

摘要

由于浸出皮革测试产生的浸出液中含有大量的铬,因此,铬盐鞣制皮革废物通常被认为是危险废物。为了解决这个问题,一种选择是回收铬,从而降低皮革废料中铬的含量。为此,采用硫酸溶液在低温下对铬鞣革屑进行浸出,旨在用最小的皮革基质侵蚀来最大程度地去除铬。研究了皮革废料尺寸、溶液中硫酸和硫酸钠浓度、提取时间和温度对铬回收的影响,并评估了有机基质的降解。铬回收的最佳条件是在 293 或 313K 下使用 25mL 浓度为 H(2)SO(4)/L 的溶液对皮革废料进行预处理 3 或 6 天。在此条件下,可回收 30-60+/-5%的铬,皮革总有机碳(TOC)的溶解率低至 3-6+/-1%。采用这种处理方法,皮革废料的面积和体积减小,残留物是一种更易碎的材料,具有增强的厌氧生物降解性。尽管取得了良好的回收效果,但由于洗脱液中铬的含量超过了阈值,因此这种废物仍然是危险废物。因此,需要对其进行系统清洗,以去除从胶原蛋白上解联的所有铬。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验