icipe-African Insect Sciences for Food and Health, Nairobi, Kenya.
Exp Appl Acarol. 2010 Aug;51(4):373-82. doi: 10.1007/s10493-009-9330-7. Epub 2010 Jan 16.
The process of strain selection is an important step in the development of insect pathogens for biological control. Bioassays were conducted in the laboratory to evaluate the efficacy of different methods of inoculation using Rhipicephalus pulchellus Gerstäcker (Acari: Ixodidae) as a model. Initially, an oil-based formulation of Metarhizium anisopliae (Metsch.) Sorok. (Ascomycota: Hypocreales) titred at 10(9) conidia ml(-1) was applied to R. pulchellus adults using a Burgerjon spray tower or a microapplicator. Inoculation by microapplicator yielded poor results (25.0% tick mortality) compared to Burgerjon's spray tower (52.3% tick mortality), although the mean number of fungal conidia on R. pulchellus adults was lower (1.5 x 10(4) +/- 1.1 x 10(3) conidia ml(-1)) after spraying by Burgerjon's spray tower compared to 1 x 10(6) conidia ml(-1) obtained with the microapplicator. Thus, inoculation by Burgerjon's spray tower was selected for further investigations. Different modes of inoculation were tested and included direct spray of inoculum on the tick and substrate (SS), direct spray on the substrate and tick followed by transfer of the tick to clean uncontaminated Petri dish (SP) or indirect inoculation of ticks through substrate (SW). The LC(50) values following contamination of nymphs (LC(50) = 1.4 x 10(7) conidia ml(-1)) and adults (LC(50) = 6.7 x 10(7) conidia ml(-1)) in SS were significantly lower compared to SP; nymphs (LC(50) = 5.7 x 10(8) conidia ml(-1)) and adults (LC(50) = 5.3 x 10(9) conidia ml(-1)) and SW; nymphs (LC(50) = 5 x 10(8) conidia ml(-1)). Although the LC(50) value in SS was the lowest, it recorded the highest tick mortality among control ticks (24.2% at 2 weeks post-treatment) and (23.3% at 3 weeks post-treatment) in nymphs and adults respectively compared to SP (2.5 and 5.8%, respectively) and SW (0.0 and 0.0). Results show that among the modes of inoculation tested, SP was the most appropriate for inoculating R. pulchellus adults. SW and SP were identified as appropriate techniques for infecting the R. pulchellus nymphs with conidia formulated in oil.
在生物防治中,昆虫病原体的开发过程中,菌株选择是一个重要的步骤。本研究通过实验室生物测定,以钝缘蜱(Rhipicephalus pulchellus Gerstäcker)为模型,评估了不同接种方法的效果。首先,采用油基制剂的金龟子绿僵菌(Metsch.)Sorok.(子囊菌门:Hypocreales)浓度为 10(9)个分生孢子/ml(-1),使用 Burgerjon 喷雾塔或微量注射器对成年钝缘蜱进行接种。与 Burgerjon 喷雾塔(52.3%的蜱死亡率)相比,微量注射器接种的效果较差(25.0%的蜱死亡率),尽管接种后成年钝缘蜱上的真菌分生孢子数量较低(1.5 x 10(4) +/- 1.1 x 10(3)个/ml(-1))(Burgerjon 喷雾塔)与使用微量注射器获得的 1 x 10(6)个/ml(-1)相比。因此,选择 Burgerjon 喷雾塔接种进行进一步研究。测试了不同的接种模式,包括直接在蜱和基质上喷洒接种物(SS)、直接在基质和蜱上喷洒接种物,然后将蜱转移到干净无污染的培养皿(SP)上,或通过基质间接接种蜱(SW)。SS 中幼虫(LC(50) = 1.4 x 10(7)个/ml(-1))和成虫(LC(50) = 6.7 x 10(7)个/ml(-1))的 LC(50)值明显低于 SP;幼虫(LC(50) = 5.7 x 10(8)个/ml(-1))和成虫(LC(50) = 5.3 x 10(9)个/ml(-1))和 SW;幼虫(LC(50) = 5 x 10(8)个/ml(-1))。尽管 SS 中的 LC(50)值最低,但与 SP(分别为 2 周和 3 周后处理的 24.2%和 5.3%)和 SW(分别为 0.0%和 0.0%)相比,控制蜱的死亡率最高(分别为 24.2%和 23.3%)。结果表明,在所测试的接种模式中,SP 是接种钝缘蜱成虫的最佳模式。SW 和 SP 被确定为用油基制剂处理钝缘蜱幼虫的合适技术。