School of Electronic and Electrical Engineering, Hongik University, Seoul 121-791, Republic of Korea.
Ultrasonics. 2010 May;50(6):592-9. doi: 10.1016/j.ultras.2009.12.004. Epub 2009 Dec 30.
An estimation of ultrasound attenuation in soft tissues is critical in the quantitative ultrasound analysis since it is not only related to the estimations of other ultrasound parameters, such as speed of sound, integrated scatterers, or scatterer size, but also provides pathological information of the scanned tissue. However, estimation performances of ultrasound attenuation are intimately tied to the accurate extraction of spectral information from the backscattered radiofrequency (RF) signals. In this paper, we propose two novel techniques for calculating a block power spectrum from the backscattered ultrasound signals. These are based on the phase-compensation of each RF segment using the normalized cross-correlation to minimize estimation errors due to phase variations, and the weighted averaging technique to maximize the signal-to-noise ratio (SNR). The simulation results with uniform numerical phantoms demonstrate that the proposed method estimates local attenuation coefficients within 1.57% of the actual values while the conventional methods estimate those within 2.96%. The proposed method is especially effective when we deal with the signal reflected from the deeper depth where the SNR level is lower or when the gated window contains a small number of signal samples. Experimental results, performed at 5MHz, were obtained with a one-dimensional 128 elements array, using the tissue-mimicking phantoms also show that the proposed method provides better estimation results (within 3.04% of the actual value) with smaller estimation variances compared to the conventional methods (within 5.93%) for all cases considered.
对软组织中的超声衰减进行估计在定量超声分析中至关重要,因为它不仅与其他超声参数(如声速、积分散射体或散射体大小)的估计有关,而且还提供了所扫描组织的病理信息。然而,超声衰减的估计性能与从背散射射频 (RF) 信号中准确提取谱信息密切相关。在本文中,我们提出了两种从背散射超声信号中计算块功率谱的新方法。这些方法基于使用归一化互相关对每个 RF 段进行相位补偿,以最小化由于相位变化引起的估计误差,以及加权平均技术以最大化信噪比 (SNR)。使用均匀数值体模进行的仿真结果表明,所提出的方法估计局部衰减系数的准确度在实际值的 1.57%以内,而传统方法的准确度在 2.96%以内。当我们处理来自较深深度的信号时,该方法特别有效,在该深度处 SNR 水平较低,或者门控窗口包含少量信号样本时。在 5MHz 处进行的实验结果是使用一维 128 个元素阵列获得的,使用组织模拟体模也表明,与传统方法(在所有考虑的情况下为 5.93%)相比,该方法提供了更好的估计结果(在实际值的 3.04%以内),并且具有更小的估计方差。