Filipiak Jaroslaw, Krawczyk Artur, Morasiewicz Leszek
Division of Biomedical Engineering and Experimental Mechanics, Wrocław University of Technology.
Acta Bioeng Biomech. 2009;11(3):3-9.
We asked how bone fragment displacement could influence the distribution of radiological density in bone regenerate formed during the process of bone lengthening. The metatarsi of 21 sheep were lengthened by 20 mm by the Ilizarov method. The bone fragments were externally fixed with a specially designed ring external fixator equipped with linear actuator driver system. The test sheep were divided into three experimental groups: the G1 and G2 groups (N = 8) and the GR group (N = 5)--the reference group. In the case of sheep from the G1 and G2 groups, the lengthening was supplemented with mechanical stimulation of the regenerate in the form of cyclic bone fragment displacements (CBFDs) with the amplitudes of 1 mm (G1) and 2 mm (G1). Mechanical stimulation was applied over 30 days for 1 h per day with a frequency of 1 Hz. Eight weeks after the procedure the sheep were sacrificed in accordance with the required procedures. The analysis of the degree of bone regenerate mineralization involved the studies based on the CT scanning. The analysis of the results obtained is based on the paramenter called the degree of regenerate mineralization (RMD). The analysis of radiological density was carried out in the selected measurement areas. Such an area was located in three horizontal zones, taking into account the regenerate height, i.e. in its middle part (half regenerate length); the top part, 2 mm from the edge of the proximal fragment; and the bottom part, 2 mm from the edge of the distal fragment. The value of the RMD parameter varies significantly, depending on the bone regenerate area. The results obtained show that the CBFD = 2 mm accelerates the rate of mineralization of an eight-week-old regenerate. In the case of CBFD = 1 mm, the mineralization rate is lower by more than a dozen per cent.
我们探讨了骨碎片移位如何影响骨延长过程中形成的骨再生组织的放射密度分布。采用伊里扎洛夫方法将21只绵羊的跖骨延长20毫米。骨碎片通过配备线性致动器驱动系统的特制环形外固定器进行外固定。实验绵羊分为三个实验组:G1组和G2组(每组8只)以及GR组(5只)——参照组。对于G1组和G2组的绵羊,在延长过程中通过以1毫米(G1组)和2毫米(G2组)的幅度进行周期性骨碎片移位(CBFD)的形式对再生组织施加机械刺激。机械刺激持续30天,每天1小时,频率为1赫兹。手术后8周,按照要求的程序处死绵羊。骨再生矿化程度的分析基于CT扫描研究。所得结果的分析基于称为再生矿化程度(RMD)的参数。在选定的测量区域进行放射密度分析。考虑到再生组织的高度,这样的区域位于三个水平区域,即在其中部(再生组织长度的一半);顶部,距离近端碎片边缘2毫米处;以及底部,距离远端碎片边缘2毫米处。RMD参数的值根据骨再生区域的不同而有显著差异。所得结果表明,CBFD为2毫米可加速8周龄再生组织的矿化速率。在CBFD为1毫米的情况下,矿化速率低了超过12%。