Department of Chemistry, Wayne State University, Detroit, MI 48202, USA.
Nanotechnology. 2010 Mar 19;21(11):115502. doi: 10.1088/0957-4484/21/11/115502. Epub 2010 Feb 22.
The photoluminescence (PL) response of highly porous CdSe aerogels to triethylamine (TEA) is investigated and compared to results from prior studies on single crystals and nanoparticle-polymer composites. As-prepared CdSe aerogels show significant and reversible enhancement of luminescence intensity upon exposure to TEA relative to the intensity in pure argon carrier gas. The enhancement in the PL response is dependent on the concentration and linear over the range of TEA concentration studied (4.7 x 10(3)-75 x 10(3) ppm). The sensing response of previously tested samples exhibits saturation behavior that is modeled using Langmuir adsorption isotherms, yielding adsorption equilibrium constants in the range 300-380 atm( - 1). The response is sensitively affected by the surface characteristics of the aerogel; when the wet gels are treated with pyridine prior to aerogel formation, the response to TEA is diminished, and when as-prepared aerogels are heated in a vacuum, no subsequent response is observed. Deactivation is attributed to an increase in surface oxide (SeO(2)) and decrease in surface Cd(2 + ) Lewis acid sites. Sensing runs of approximately one hour have little impact on the morphology or crystallinity of the aerogels, but do result in partial removal of residual thiolate ligands left over from the gelation process.
高度多孔的 CdSe 气凝胶对三乙胺(TEA)的光致发光(PL)响应进行了研究,并与单晶和纳米粒子-聚合物复合材料的先前研究结果进行了比较。与在纯氩载气中的强度相比,制备的 CdSe 气凝胶在暴露于 TEA 时显示出显著且可恢复的发光强度增强。PL 响应的增强取决于浓度,并且在研究的 TEA 浓度范围内呈线性(4.7 x 10(3)-75 x 10(3) ppm)。先前测试的样品的传感响应表现出饱和行为,使用 Langmuir 吸附等温线对其进行建模,得到的吸附平衡常数在 300-380 atm( - 1)范围内。响应受到气凝胶表面特性的敏感影响;当在形成气凝胶之前用吡啶处理湿凝胶时,对 TEA 的响应会减弱,而当在真空中加热预制气凝胶时,则不会观察到后续响应。失活归因于表面氧化物(SeO(2))的增加和表面 Cd(2 + )路易斯酸位的减少。大约一小时的传感运行对气凝胶的形态或结晶度几乎没有影响,但确实导致残留的硫醇配体从凝胶过程中部分去除。