School of Engineering Sciences, Royal Institute of Technology, Stockholm, Sweden.
Ultrasonics. 2011 Jan;51(1):40-8. doi: 10.1016/j.ultras.2010.05.006. Epub 2010 May 24.
The focus of contrast-enhanced ultrasound research has developed beyond visualizing the blood pool and its flow to new areas such as perfusion imaging, drug and gene therapy, and targeted imaging. In this work comparison between the application of polymer- and phospholipid-shelled ultrasound contrast agents (UCAs) for characterization of the capillary microcirculation is reported. All experiments are carried out using a microtube as a vessel phantom. The first set of experiments evaluates the optimal concentration level where backscattered signal from microbubbles depends on concentration linearly. For the polymer-shelled UCAs the optimal concentration level is reached at a value of about 2×10(4)MB/ml, whereas for the phospholipid-shelled UCAs the optimal level is found at about 1×10(5)MB/ml. Despite the fact that the polymer shell occupies 30% of the radius of microbubble, compared to 0.2% of the phospholipid-shelled bubble, approximately 5-fold lower concentration of the polymer UCA is needed for investigation compared to phospholipid-shelled analogues. In the second set of experiments, destruction/replenishment method with varied time intervals ranging from 2ms to 3s between destructive and monitoring pulses is employed. The dependence of the peak-to-peak amplitude of backscattered wave versus pulse interval is fitted with an exponential function of the time γ=A(1-exp(-βt)) where A represents capillary volume and the time constant β represents velocity of the flow. Taking into account that backscattered signal is linearly proportional to the microbubble concentration, for both types of the UCAs it is observed that capillary volume is linearly proportional to the concentration of the microbubbles, but the estimation of the flow velocity is not affected by the change of the concentration. Using the single capillary model, for the phospholipid-shelled UCA a delay of about 0.2-0.3s in evaluation of the perfusion characteristics is found while polymer-shelled UCA provide response immediately. The latter at the concentration lower than 3.6×10(5)MB/ml have no statistically significant delay (p<0.01), do not cause any attenuation of the backscattered signal or saturation of the receiving part of the system. In conclusion, these results suggest that the novel polymer-shelled microbubbles have a potential to be used for perfusion evaluation.
对比增强超声研究的重点已经从观察血池及其流动发展到新的领域,如灌注成像、药物和基因治疗以及靶向成像。本工作报道了比较聚合物壳和磷脂壳超声造影剂(UCAs)在毛细血管微循环特征化中的应用。所有实验均使用微管作为血管模型进行。第一组实验评估了背向散射信号随微泡浓度线性变化的最佳浓度水平。对于聚合物壳 UCAs,最佳浓度水平在约 2×10(4)MB/ml 时达到,而对于磷脂壳 UCAs,最佳水平在约 1×10(5)MB/ml 时达到。尽管聚合物壳占据微泡半径的 30%,而磷脂壳仅占 0.2%,但与磷脂壳 UCAs 相比,聚合物 UCA 的浓度低约 5 倍即可进行研究。在第二组实验中,采用破坏/补充方法,在破坏脉冲和监测脉冲之间的时间间隔从 2ms 到 3s 不等。背向散射波的峰峰值幅度与脉冲间隔的关系用指数函数拟合 γ=A(1-exp(-βt)),其中 A 代表毛细血管体积,时间常数β代表流速。考虑到背向散射信号与微泡浓度成正比,对于两种类型的 UCAs,观察到毛细血管体积与微泡浓度成正比,但流速的估计不受浓度变化的影响。使用单毛细管模型,对于磷脂壳 UCAs,在评估灌注特性时发现延迟约 0.2-0.3s,而聚合物壳 UCAs 则立即响应。后者在浓度低于 3.6×10(5)MB/ml 时没有统计学上的显著延迟(p<0.01),不会引起背向散射信号的衰减或系统接收部分的饱和。总之,这些结果表明新型聚合物壳微泡具有用于灌注评估的潜力。