Department of Mechanical Engineering, National Cheng Kung University, No. 1, Ta-Hsueh Road, Tainan, Taiwan.
Talanta. 2010 Aug 15;82(3):1044-51. doi: 10.1016/j.talanta.2010.06.020. Epub 2010 Jun 23.
This paper presents a highly sensitive oxygen sensor that comprises an optical fiber coated at one end with platinum(II) meso-tetrakis(pentafluorophenyl)porphyrin (PtTFPP) and PtTFPP entrapped core-shell silica nanoparticles embedded in an n-octyltriethoxysilane (Octyl-triEOS)/tetraethylorthosilane (TEOS) composite xerogel. The sensitivity of the optical oxygen sensor is quantified in terms of the ratio I(0)/I(100), where I(0) and I(100) represent the detected fluorescence intensities in pure nitrogen and pure oxygen environments, respectively. The experimental results show that the oxygen sensor has a sensitivity (I(0)/I(100)) of 166. The response time was 1.3s when switching from pure nitrogen to pure oxygen, and 18.6s when switching in the reverse direction. The experimental results show that compared to oxygen sensors based on PtTFPP, PtOEP, or Ru(dpp)(3)(2+) dyes, the proposed optical fiber oxygen sensor has the highest sensitivity. In addition to the increased surface area per unit mass of the sensing surface, the dye entrapped in the core of silica nanoparticles also increases the sensitivity because a substantial number of aerial oxygen molecules penetrate the porous silica shell. The dye entrapped core-shell nanoparticles is more prone to oxygen quenching.
本文提出了一种高灵敏度的氧传感器,该传感器由一端涂覆有铂 (II) 中四 (五氟苯基) 卟啉 (PtTFPP) 的光纤和嵌入在正辛基三乙氧基硅烷 (Octyl-triEOS)/四乙氧基硅烷 (TEOS) 复合干凝胶中的 PtTFPP 包埋核壳硅纳米粒子组成。光纤氧传感器的灵敏度用 I(0)/I(100) 的比值来定量,其中 I(0) 和 I(100) 分别代表在纯氮气和纯氧气环境下检测到的荧光强度。实验结果表明,该氧传感器的灵敏度 (I(0)/I(100)) 为 166。从纯氮气切换到纯氧气时,响应时间为 1.3s,而反向切换时为 18.6s。实验结果表明,与基于 PtTFPP、PtOEP 或 Ru(dpp)(3)(2+) 染料的氧传感器相比,所提出的光纤氧传感器具有最高的灵敏度。除了单位质量传感表面的表面积增加外,嵌入在硅纳米粒子核中的染料也增加了灵敏度,因为大量的气态氧分子穿透多孔硅壳。嵌入核壳纳米粒子的染料更容易发生氧猝灭。