Flinck Marianne, Gradén Asa, Milde Helén, Flinck Agneta, Hellström Mikael, Björk Jonas, Nyman Ulf
Department of Radiology, Sahlgrenska University Hospital and Sahlgrenska Academy at Gothenburg University, Sweden.
Acta Radiol. 2010 Oct;51(8):895-902. doi: 10.3109/02841851.2010.503663.
Cardiac output (CO) is inversely related to vascular contrast medium (CM) enhancement during computed tomography (CT). Impedance cardiography with a new technique, electrical velocimetry (EV), may create opportunities to measure CO pre-examination for adaptation of CM injection parameters.
To relate CO(EV) measured by radiology staff to aortic attenuation as a measure of coronary artery attenuation during CT coronary angiography (CTCA), and to formulate a tentative statistical model to adapt CM injection parameters to CO.
CO(EV) was measured immediately before 100 kVp CTCA (64-multirow detector) in 27 patients with presumed coronary artery disease. For CTCA, 260 mg I/kg (maximum dosage weight: 80/90 kg for women/men) was injected intravenously during 12 s. Simple linear regression analysis was performed to explore the correlation between aortic attenuation (Hounsfield units, HU) and body weight, the influence of CO(EV) on aortic attenuation adjusted to injected CM dose rate (HU per mg I/kg/s), and to establish a tentative formula on how to adapt CM injection parameters to CO(EV) and desired aortic attenuation.
The correlation between aortic attenuation and body weight was weak and non-significant (r=-0.14 after outlier exclusion). A significant negative correlation (r=-0.63) was found between aortic attenuation adjusted to injected CM dose rate (HU per mg I/kg/s) and CO(EV). The resulting formula, CM dose rate=CO(EV)×(aortic attenuation-240)/55, made it possible to calculate CM volumes and injection rates at various COs and, for example, the present mean aortic attenuation (438 HU), injection time (12 s), CM concentration (320 mg I/ml), and a certain body weight.
EV makes it possible to measure CO in the CT suite before vascular examinations. Hence, CM doses may be decreased in low CO states to reduce the risk of CM-induced nephropathy without jeopardizing diagnostic quality and may be increased in high CO states to avoid poor enhancement.
在计算机断层扫描(CT)期间,心输出量(CO)与血管造影剂(CM)增强呈负相关。采用新技术——电测速法(EV)的阻抗心动图可能为在检查前测量CO以调整CM注射参数创造机会。
将放射科工作人员测量的CO(EV)与主动脉衰减相关联,作为CT冠状动脉造影(CTCA)期间冠状动脉衰减的一种测量方法,并制定一个初步的统计模型,以便根据CO调整CM注射参数。
在27例疑似冠心病患者进行100 kVp的CTCA(64排探测器)之前,立即测量CO(EV)。对于CTCA,在12秒内静脉注射260 mg I/kg(女性/男性最大剂量体重:80/90 kg)。进行简单线性回归分析,以探讨主动脉衰减(亨氏单位,HU)与体重之间的相关性、CO(EV)对根据注射的CM剂量率调整后的主动脉衰减(每mg I/kg/s的HU)的影响,并建立一个关于如何根据CO(EV)和所需主动脉衰减调整CM注射参数的初步公式。
主动脉衰减与体重之间的相关性较弱且无统计学意义(排除异常值后r = -0.14)。在根据注射的CM剂量率调整后的主动脉衰减(每mg I/kg/s的HU)与CO(EV)之间发现显著的负相关(r = -0.63)。所得公式为CM剂量率 = CO(EV)×(主动脉衰减 - 240)/55,这使得能够计算不同CO下的CM体积和注射速率,例如,当前平均主动脉衰减(438 HU)、注射时间(12秒)、CM浓度(320 mg I/ml)以及特定体重时的情况。
EV使得在血管检查前在CT检查室测量CO成为可能。因此,在低CO状态下可降低CM剂量以降低CM诱导的肾病风险,同时不影响诊断质量;在高CO状态下可增加CM剂量以避免增强不佳。