Effect of disinfecting solutions on surface texture of alginate and elastomeric impressions.

The effect of immersion in six disinfecting solutions on the surface texture of 10 impression materials was investigated. Assessment of the surface texture was based on measurement of the ability to reproduce fine detail. Impressions were taken of a roughness standard, i.e. a steel block with known roughness. After setting, the impressions were either stored at room temperature for 24 h, for control, or immediately immersed in a disinfecting agent for 60 min (in one case 10 min), and after 24 h poured with gypsum. After another 24 h, the roughness of the dies was recorded with a profilometer. Three addition-curing silicones were left unaltered by disinfection. For the remaining seven materials, the ability of detail reproduction was changed for some of the combinations of impression material and disinfecting solution. In general, this meant a reduction of detail reproduction, but occasionally an improvement of the surface texture resulted from disinfection. Changes in surface texture were most often brought about by a solution of chlorinated trisodium phosphate. It was concluded that elastomeric impression materials reproduced fine detail better than did alginates and that both types of impression material may be immersed in specific disinfecting solutions for as long as 1 h without the surface texture being impaired.