Department of Pediatrics, Children's Hospital of Philadelphia, Philadelphia, PA 19104, USA.
Bone. 2011 May 1;48(5):1103-8. doi: 10.1016/j.bone.2011.01.005. Epub 2011 Jan 15.
Muscle and bone form a functional unit. While muscle size is a useful surrogate of mechanical load on bone, the independent contributions to bone strength of muscle force, muscle size, gravitational load (body weight), and physical activity have not been assessed. Three hundred twenty-one healthy participants (32% black, 47% male), aged 5-35 years were assessed. Peak dorsiflexion muscle torque (ft-lbs) of the ankle was assessed using isometric dynamometry. Tibia peripheral quantitative computed tomography measures included polar section modulus (Zp; mm(3)), periosteal and endosteal circumference (mm), cortical area (mm(2)), and volumetric bone mineral density (vBMD; mg/cm(3)) at the 38% site, and muscle cross-sectional area (CSA; mm(2)), at the 66% site. Physical activity (average hours per week) was assessed by questionnaire. Log linear regression was used to assess determinants of muscle specific force (MSF; torque relative to muscle CSA) and Zp adjusted for age and tibia length. MSF was greater in blacks than whites (p<0.05) and lower in females than males (p<0.001). Zp was greater in blacks than whites (p=0.002) in Tanner stages 1-4, but the difference was attenuated in Tanner 5 (interaction, p=0.02); R(2)=0.87. Muscle CSA, muscle torque, body weight, and physical activity were added to the model and each load covariate was independently and significantly (all, p<0.02) associated with Zp (R(2)=0.92), periosteal circumference, and cortical area. Inclusion of these measures attenuated but did not eliminate the significant race differences. Only muscle CSA was positively associated with endosteal circumference, while none of the load covariates were associated with vBMD. In conclusion, bone geometry is associated with several factors that define the mechanical load on bone, independent of age, tibia length, maturation, race, and sex. Race differences in Zp were not explained by these measures of mechanical load. Given that inclusion of muscle torque, body weight, and physical activity resulted in a nominal increase in the R(2), muscle size is an adequate surrogate for the mechanical load on bone in healthy participants.
肌肉和骨骼构成了一个功能单元。虽然肌肉大小是骨骼机械负荷的一个有用替代指标,但肌肉力量、肌肉大小、重力负荷(体重)和身体活动对骨骼强度的独立贡献尚未得到评估。本研究共纳入了 321 名健康参与者(32%为黑人,47%为男性),年龄在 5-35 岁之间。采用等速测力法评估踝部背屈峰值肌肉扭矩(ft-lbs)。胫骨外周定量计算机断层扫描(pQCT)测量指标包括极部截面模数(Zp;mm(3))、骨皮质内外径(mm)、皮质骨面积(mm(2))和 38%部位的体积骨密度(vBMD;mg/cm(3)),以及 66%部位的肌肉横截面积(CSA;mm(2))。身体活动(每周平均小时数)通过问卷进行评估。采用对数线性回归分析评估肌肉比力量(MSF;相对于肌肉 CSA 的扭矩)和 Zp 的年龄和胫骨长度校正后的决定因素。黑人的 MSF 高于白人(p<0.05),女性低于男性(p<0.001)。Tanner 分期 1-4 期的黑人 Zp 高于白人(p=0.002),但在 Tanner 5 期时差异减弱(交互作用,p=0.02);R(2)=0.87。将肌肉 CSA、肌肉扭矩、体重和身体活动添加到模型中,每个负荷协变量均与 Zp(R(2)=0.92)、骨皮质内外径和皮质骨面积独立且显著相关(均为 p<0.02)。包含这些指标后,种族差异虽有所减弱但仍有统计学意义。只有肌肉 CSA 与骨内径呈正相关,而负荷协变量均与 vBMD 无相关性。总之,骨骼几何形状与定义骨骼机械负荷的多个因素相关,与年龄、胫骨长度、成熟度、种族和性别无关。Zp 的种族差异不能用这些机械负荷指标来解释。鉴于肌肉扭矩、体重和身体活动的纳入使 R(2)略有增加,肌肉大小是健康参与者骨骼机械负荷的一个充分替代指标。