VA HSR&D/RR&D Center of Excellence in Maximizing Rehabilitation Outcomes, James A. Haley VA Hospital, 8900 Grand Oak Circle, Room 149, Tampa, FL 33637-1022, USA.
J Biomech. 2011 Apr 29;44(7):1277-84. doi: 10.1016/j.jbiomech.2011.02.010. Epub 2011 Feb 26.
Toe speed during gait generally nears its maximum while its height reaches a local minima approximately halfway through swing phase. Trips are thought to frequently occur at these local minima (minimum toe clearance or MTC events) and trip risk has been quantified using the minimum distance between the toe and ground here (MTC). This study investigated MTC on floor surfaces with and without multiple small obstacles. After shoes and floor surfaces were digitized, 14 unimpaired subjects (half women) each traversed a 4.88 m walkway 4 times at slow, preferred, and fast speeds across surfaces with no obstacles, visible obstacles, and hidden obstacles. Both surfaces with obstacles had the same random obstacle configuration. Shoe and body segment motions were tracked using passive markers and MTC and joint kinematics calculated. All MTC and kinematic variables tested significantly increased with faster instructed gait speed except the likelihood of MTC event occurrence (local minima in minimum toe clearance trajectory when foot is in upper quartile of speed). MTC events were less frequent for swing phases on surfaces with obstacles (80% vs. 98% for no obstacles). MTC values, when present, were doubled by the presence of visible obstacles (22.2 ± 7.3mm vs. 11.1 ± 5.7 mm) and further increased to 26.8 ± 7.1mm when these obstacles were hidden from view (all comparisons p ≤ 0.0003). These substantial floor surface-related changes in MTC event occurrences and values resulted from alterations in toe- and heel-clearance trajectories caused by subtle but significant changes in joint kinematics that did not exceed 10% each joint's swing phase range of motion.
在步态中,脚趾速度通常在其高度达到摆动相中间的局部最小值时接近最大值。人们认为,绊倒通常发生在这些局部最小值(最小脚趾间隙或 MTC 事件)处,并且已经使用此处脚趾与地面之间的最小距离(MTC)来量化绊倒风险。本研究调查了具有和不具有多个小障碍物的地板表面上的 MTC。在数字化鞋子和地板表面后,14 名未受损的受试者(一半为女性)每人在无障碍物、可见障碍物和隐藏障碍物的情况下,以慢、快和快的速度在 4.88 米长的走道上各走 4 次。两个有障碍物的表面都具有相同的随机障碍物配置。使用被动标记器跟踪鞋子和身体节段的运动,并计算 MTC 和关节运动学。除了 MTC 事件发生的可能性(当脚处于速度的上四分位数时,最小脚趾间隙轨迹中的局部最小值)外,所有 MTC 和运动学变量都随着更快的指令步行速度显著增加,除了 MTC 事件发生的可能性(当脚处于速度的上四分位数时,最小脚趾间隙轨迹中的局部最小值)外,所有 MTC 和运动学变量都随着更快的指令步行速度显著增加,除了 MTC 事件发生的可能性(当脚处于速度的上四分位数时,最小脚趾间隙轨迹中的局部最小值)外,所有 MTC 和运动学变量都随着更快的指令步行速度显著增加,除了 MTC 事件发生的可能性(当脚处于速度的上四分位数时,最小脚趾间隙轨迹中的局部最小值)外,所有 MTC 和运动学变量都随着更快的指令步行速度显著增加。在障碍物表面上,摆动阶段的 MTC 事件发生频率较低(无障碍物为 80%,有障碍物为 98%)。当这些障碍物被隐藏起来看不见时,MTC 值(如果存在)增加了一倍(22.2 ± 7.3mm 对 11.1 ± 5.7mm),并且进一步增加到 26.8 ± 7.1mm(所有比较 p ≤ 0.0003)。这些与地板表面相关的 MTC 事件发生和值的巨大变化是由于脚趾和脚跟间隙轨迹的变化引起的,这些变化是由关节运动学的细微但显著变化引起的,每个关节的摆动阶段运动范围都不超过 10%。