Department of Physics, Umeå University, 901 87 Umeå, Sweden.
J Chem Phys. 2011 Mar 28;134(12):124903. doi: 10.1063/1.3568817.
We report a study of aqueous solutions of poly(vinylalcohol) and its hydrogel by thermal conductivity, κ, and specific heat measurements. In particular, we investigate (i) the changes in the solution and the hydrogel at 0.1 MPa observed in the 350-90 K range and of the frozen hydrogel at 130 K observed in the range from 0.1 MPa to 1.3 GPa, and (ii) the nature of the pressure collapse of ice in the frozen hydrogel and kinetic unfreezing on heating of its high density water at 1 GPa. The water component of the polymer solution on cooling either first phase separates and then freezes to hexagonal ice or freezes without phase separation and the dispersed polymer chains freeze-concentrate in nanoscopic and microscopic regions of the grain boundaries and grain junctions of the ice crystals in the frozen state of water in the hydrogel. The change in κ with temperature at 1 bar is reversible with some hysteresis, but not reversible with pressure after compression to 0.8 GPa at 130 K. At high pressures the crystallized state collapses showing features of κ and specific heat characteristic of formation of high density amorphous solid water. The pressure of structural collapse is 0.08 GPa higher than that of ice at 130 K. The slowly formed collapsed state shows kinetic unfreezing or glass-liquid transition temperature at 140 K for a time scale of 1 s. Comparison with the change in the properties observed for ice shows that κ decreases when the polymer is added.
我们报告了通过热导率 κ 和比热测量对聚乙烯醇及其水凝胶的水溶液的研究。特别是,我们研究了(i)在 350-90 K 范围内观察到的 0.1 MPa 下的溶液和水凝胶的变化,以及在 0.1 MPa 至 1.3 GPa 范围内观察到的 130 K 下冷冻水凝胶的变化,以及(ii)在冷冻水凝胶中冰的压力坍塌的性质以及在 1 GPa 下对其高密度水进行加热时的动力学解冻。聚合物溶液中的水组分要么先相分离然后冷冻成六方冰,要么在没有相分离的情况下冷冻,分散的聚合物链在水凝胶中水的冷冻状态下在冰晶的晶粒边界和晶粒连接处的纳米和微观区域中冷冻浓缩。在 1 巴下,κ 随温度的变化具有一定的滞后性,但在 130 K 下压缩至 0.8 GPa 后,它不能随压力可逆变化。在高压下,结晶状态坍塌,表现出 κ 和比热特征,形成高密度非晶态水。结构坍塌的压力比 130 K 时的冰高 0.08 GPa。形成的坍塌状态缓慢形成,在 140 K 下具有动力学解冻或玻璃-液体转变温度,时间尺度为 1 s。与冰的性质变化进行比较表明,加入聚合物时 κ 会降低。