Department of Chemical and Materials Engineering, National Kaohsiung University of Applied Sciences, 80782 Kaohsiung, Taiwan.
Phys Chem Chem Phys. 2011 May 28;13(20):9407-17. doi: 10.1039/c0cp02416c. Epub 2011 Apr 11.
The product alignment and orientation of the title reaction on the ground potential energy surface of 1 (2)A' have been studied using the quasi-classical trajectory method. The calculations were carried out for case (a) at collision energies of 0.5-20 kcal mol(-1) with the initially rovibrational state of the reagent FCl molecule being at the v = 0 and j = 0 level to especially reveal in detail the dependence of the product integral cross section on collision energy. Further calculations at the collision energy of 15 kcal mol(-1) for case (b) at v = 0-5, and j = 0, and (c) at v = 0, and j = 3, 6, 9 initial states were carried out to reveal the effect of initially vibrational and rotational excitations on stereodynamics, respectively. Possessing final relative velocity k' (defined as a vector in the xz-plane), product alignment perpendicular to the reagent relative velocity vector k (defined as z- or parallel to the z-axis), for case (a) is found to be weaker at all collision energies, for case (b) is found to be vibrationally enhanced by the reactant molecule FCl, but for case (c), rather insensitive to initially rotational excitation. The rotational vector of product molecular orientation pointing to either negative or positive direction of the y-axis in the center of mass frame, e.g. origin of the coordinate system, is enhanced by collision energies regarding to 0.5-20 kcal mol(-1), while it becomes weaker at higher vibrational (v = 0-5) or rotational (j = 0, 3, 6, 9) excitation levels. Effects of collision energies and of rotational excitation at these collision energies, with 15 kcal mol(-1) as an example on the calculated PDDCSs are also shown and discussed. Detailed plots P(φ(r)) in the range of 0 ≤φ(r)≤ 360(o), and P(θ(r), φ(r)) in the ranges of 0 ≤θ(r)≤ 180° and 0 ≤φ(r)≤ 360° at collision energies 0.5-20 kcal mol(-1) have been presented. Overall, results of PDDCSs of the product alignment and product orientation at these collision energies in the title reaction are not very strongly distinguishable.
使用准经典轨迹方法研究了标题反应在 1(2)A' 基态势能面上的产物取向和定向。计算针对案例 (a) 在碰撞能为 0.5-20 kcal mol(-1) 时进行,试剂 FCl 分子的初始振动态处于 v = 0 和 j = 0 能级,特别详细地揭示了产物积分截面对碰撞能的依赖性。在碰撞能为 15 kcal mol(-1) 时,针对案例 (b) 在 v = 0-5 和 j = 0,以及案例 (c) 在 v = 0 和 j = 3、6、9 初始态进一步进行了计算,分别揭示了初始振动和转动激发对立体动力学的影响。产物分子取向的最终相对速度 k'(定义为 xz 平面中的一个向量),垂直于试剂相对速度向量 k(定义为 z 方向或平行于 z 轴),对于案例 (a) 在所有碰撞能下都较弱,对于案例 (b) 被反应物分子 FCl 增强,但对于案例 (c),对于初始转动激发不太敏感。产物分子取向的旋转向量指向质心坐标系中 y 轴的正或负方向,例如坐标系的原点,在 0.5-20 kcal mol(-1) 范围内随着碰撞能的增加而增强,而在更高的振动(v = 0-5)或转动(j = 0、3、6、9)激发水平下变得较弱。以 15 kcal mol(-1) 为例,还展示和讨论了碰撞能和这些碰撞能下的转动激发对计算得到的 PDDCSs 的影响。在 0.5-20 kcal mol(-1) 的碰撞能范围内,给出了 0 ≤φ(r)≤ 360(o)范围内的 P(φ(r))和 0 ≤θ(r)≤ 180°和 0 ≤φ(r)≤ 360°范围内的 P(θ(r), φ(r))的详细图。总体而言,在这些碰撞能下,标题反应产物取向和产物定向的 PDDCSs 的结果不太容易区分。