Suppr超能文献

SPECT/CT 中高级迭代重建方法的比较。

Comparison of advanced iterative reconstruction methods for SPECT/CT.

机构信息

Department of Nuclear Medicine and PET Center, Wilhelminenspital, Vienna, Austria.

出版信息

Z Med Phys. 2012 Feb;22(1):58-69. doi: 10.1016/j.zemedi.2011.04.007. Epub 2011 Jul 1.

Abstract

AIM

Corrective image reconstruction methods which produce reconstructed images with improved spatial resolution and decreased noise level became recently commercially available. In this work, we tested the performance of three new software packages with reconstruction schemes recommended by the manufacturers using physical phantoms simulating realistic clinical settings.

METHODS

A specially designed resolution phantom containing three (99m)Tc lines sources and the NEMA NU-2 image quality phantom were acquired on three different SPECT/CT systems (General Electrics Infinia, Philips BrightView and Siemens Symbia T6). Measurement of both phantoms was done with the trunk filled with a (99m)Tc-water solution. The projection data were reconstructed using the GE's Evolution for Bone(®), Philips Astonish(®) and Siemens Flash3D(®) software. The reconstruction parameters employed (number of iterations and subsets, the choice of post-filtering) followed theses recommendations of each vendor. These results were compared with reference reconstructions using the ordered subset expectation maximization (OSEM) reconstruction scheme.

RESULTS

The best results (smallest value for resolution, highest percent contrast values) for all three packages were found for the scatter corrected data without applying any post-filtering. The advanced reconstruction methods improve the full width at half maximum (FWHM) of the line sources from 11.4 to 9.5mm (GE), from 9.1 to 6.4mm (Philips), and from 12.1 to 8.9 mm (Siemens) if no additional post filter was applied. The total image quality control index measured for a concentration ratio of 8:1 improves for GE from 147 to 189, from 179. to 325 for Philips and from 217 to 320 for Siemens using the reference method for comparison. The same trends can be observed for the 4:1 concentration ratio. The use of a post-filter reduces the background variability approximately by a factor of two, but deteriorates significantly the spatial resolution.

CONCLUSIONS

Using advanced reconstruction algorithms the largest improvement in image resolution and contrast is found for the scatter corrected slices without applying post-filtering. The user has to choose whether noise reduction by post-filtering or improved image resolution fits better a particular imaging procedure.

摘要

目的

最近推出了一些可生成具有更高空间分辨率和更低噪声水平的重建图像的校正图像重建方法,这些方法已经商业化。在这项工作中,我们使用制造商推荐的重建方案,用模拟真实临床环境的物理体模测试了三个新软件包的性能。

方法

使用专门设计的分辨率体模(其中包含三个 99mTc 线源)和 NEMA NU-2 图像质量体模,在三个不同的 SPECT/CT 系统(通用电气公司的 Infinia、飞利浦的 BrightView 和西门子的 Symbia T6)上采集数据。对装有 99mTc-水溶液的体模进行测量。使用 GE 的 Evolution for Bone(®)、飞利浦的 Astonish(®)和西门子的 Flash3D(®)软件对投影数据进行重建。所采用的重建参数(迭代次数和子集数、后置滤波的选择)遵循每个供应商的建议。将这些结果与使用有序子集期望最大化(OSEM)重建方案的参考重建结果进行比较。

结果

对于所有三个软件包,在散射校正数据中找到的结果最好(分辨率值最小,对比度百分比最高),没有应用任何后置滤波。如果不应用额外的后置滤波,高级重建方法可以将线源的全宽半最大值(FWHM)从 11.4 毫米提高到 9.5 毫米(GE)、从 9.1 毫米提高到 6.4 毫米(飞利浦)和从 12.1 毫米提高到 8.9 毫米(西门子)。如果使用参考方法进行比较,对于浓度比为 8:1,GE 的总图像质量控制指数从 147 提高到 189,飞利浦从 179 提高到 325,西门子从 217 提高到 320。对于 4:1 的浓度比,可以观察到相同的趋势。使用后置滤波可以将背景变化降低约两倍,但会显著降低空间分辨率。

结论

在不应用后置滤波的情况下,使用散射校正切片和高级重建算法可以最大程度地提高图像分辨率和对比度。用户必须选择通过后置滤波来降低噪声还是提高图像分辨率更适合特定的成像过程。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验